UK-POLOS.NET - THE VW Polo Forum

Check the wires that go through the a-post to the door these wires could have water in the terminals.This problem causes the terminals to corrode and then opens the door control unit.

:D :D
After starting the engine the ABS warning light flashes shortly and a warning signal sounds 3 times.

Cause:
If the ignition is switched on and the engine is started after the warning lights go out.
During the ABS check and the engine start the power system drops below 9.1 V, which triggers ...

This beeping noise is normal you could insist that your dealer changes this cluster.

This was an update to the software in the cluster.The cluster is testing the signal to the voltage control unit.And this is where you get these beeps.You will find if you switch all your consumers off and your battery is fully charged you should not hear this noise at times.
Cheers

:D The only way to get supply wires from the engine to the drivers area is through the main junction connector.This can be found under the front wiper motor.
You will have to remove the wiper arms(both)Then remove the rubber seal that runs across the plastic firewall cover.The plasic cover over the ...