UK-POLOS.NET - THE VW Polo Forum

😂😂 Will do! The top and bottom of it is I was under the impression that as I had already got the polo 6R xenon/LED headlights fitted, from the factory, genuine (14 pin plug) that as the polo 6C (facelift essentially) would just work as the old ones did but the side lights and the “parking” lights (w...

Yes, parking light comes on for 3 seconds then goes off, no sidelights but got main beam (xenon)

Thanks, the car is already wired up from factory for the 6R xenon rline lights (14 pin plug, etc..) So don’t think wiring is the issue?? They’re just the later model? I’ve been checking voltage etc… tonite and gettin no answers so coding is looking like the answer 🤷🏼‍♂️ Would you think it would just...

Hope this is ok to post as I’m pulling my hair out here; I have a Vw polo 1.2 tsi 6R R-line polo 2013 with factory xenon’s But fitted polo 6C bi-xenon with LED’s (genuine) 2015 headlights But the parking/side lights only come on for 2 seconds then off, everything else fine. It has fault codes: 02896...

Thanks again, would I be right in thinking the 6C lights are completely LED (no xenon)?? As my Rline’s are LED and xenon already?!?!?

Thanks for the reply, I had looked into that, would it have to be a BCM from a 6C car as my car already has the “extras” like rain sensor, light sensor, headlight levelling, headlight washers, etc... Forgive me if it sounds like I don’t know what I’m on about, i just read that those are the extras y...

I have a 6R rline with factory fitted xenon headlights and have had a little bump and need replacing! I’m thinking of fitting the 6C xenon/LED lights as both wiring plugs are 14 pin, I’m wanting to know if anyone knows wether these will just fit and work??? Can only find info on changing standard ha...

Sayin got ECM disabled on the solus when I've plugged it in as I'd tried the usual stuff????

Help!!! Dash isn't lighting up when ignitions on and fires up then cuts straight out so plugged into solus and says "ECM module disabled" what's my options here?!! Only ran out of fuel and its lead to this!!!!

Polo 1.2 2013 ran out of fuel at work so put 10 litres of fuel and tried starting, first thing was that there were no lights on the dash on ignition no:1 then the car fired then cut straight out after 2 seconds of running!! Not done anything other than run out of fuel and try n start it???!! Any hel...

Does anyone know if I can order just a key blade for my 6r polo as I have acquired a fob?! I have someone in mind for the coding but didnt know wether you could just buy the blade to the chassis number from VW??

Which out of the 3 wires do you test too??!! Didn't think about that!

I'm going to try and measure what ohms are going through the side airbag that I've got a fault on to check if it's the bag or wiring, does anyone know what measurement I should be looking for or anywhere that will tell me??

Tried through vcds to reset/calibrate this just now but says "aborted safety reasons" any ideas??
I did change the sensor for a new 1 but didn't think it needed coding or is this the reason why it's saying this??

Thanks for your help