UK-POLOS.NET - THE VW Polo Forum

Hi all I have a 2008 VW Polo 9n3 1.2 5Dr which has only electric windows in the front. A few weeks ago they started to play up only working intermittently now to cease to working at all via any of the windows switches in both the passenger door and driver’s door. Both windows still go up and down b...

Reflex silver,,definitely,, , satin was the earlier colour,

Should be the same, but not dangerous,

My daughter s tdi 2007 1.9 the same, will be fine for days then travel over halfway to the floor, no fluid loss, but can here air escaping behind pedal every time i press it,,, next day... Fine,,,,???

flanagaj wrote:I have found a company in Cornwall who do a whole exchange head for £225 + vat. Given the trouble I have had with the head on this one I think I am just going to go down that route.

I agree,best of luck

Sent from my CLT-L09 using Tapatalk

SO having removed the head I turned it upside down and filled each of the cylinder tops with water. Low and behold water quickly started draining from number 1 and out of the exhaust port. In fact I put my bright led light into the exhaust port hole and you could clearly see the ring of light aroun...

Beginning of May I stripped down my Daughter's 3 cylinder BMD engine and had new valve seats and the head skimmed as a result of poor compression. This solved the problem and the car ran fine. Cut a long story short the engine management light came on yesterday and it went into limp mode. Got the v...

Thankyou, where will the end of the loom that I connect the CD changer into be located ?? If the cd is separate,you need a ft long joining cable,that links the stereo to the cd unit, I've got one hanging in my garage,,been there years, should b the right one,don't think they are expensive,few quid,...

Sarim wrote:I think it'll be a separate loom that plugs into the back of the stock head unit

Sent from my SM-G935F using Tapatalk

Can get a plug in harness from Halfords,but your existing plug s should plug in,

Sent from my CLT-L09 using Tapatalk

What happens is,the connection near the abs block behind the battery comes disconnected,normally by operating the washer while still frozen,I had six like it over the years,simple job,battery off makes life easier,fill up the bottle,open bonnet,get someone to operate the washers,you will then find t...

Thanks for the reply. I don't know when the belt+pump was replaced. Just picked up new expansion tank, if weather permits, I'll make a start this afternoon and try bleeding system through. Fan is free moving, so would indicate problem with power to..... I've taken on board your suggestions, will pl...

Do some continuity testing with a multimeter on Ohms (resistance) and check there are no rogue values between the chassis plug and the window and door lock plugs Thanks ill dig in again...just to add..if i open the pas door with the key..then get in car..window will work from its switch fine.'till ...

alexperkins wrote:Continually posting on this wont prompt a reply

I would look into changing the door wiring loom to the body before you do anything further.

Have removed both of them no breaks...[emoji31]

Sent from my SM-G950F using Tapatalk

Hi guys! Just bought the above car for my daughter as a first vehicle and totally love it. I have just one niggle that I am working on, and that is the electric window on the passenger side. I have trawled the forum and have seen lots of electric window issues, along with pointers on how to fix. Ha...

Anyone.....

Sent from my SM-G950F using Tapatalk