UK-POLOS.NET - THE VW Polo Forum

Just connect the red lead from red plug and yellow one to one wire, and connect it to reverse positive. And black wire from the red plug to.ground ( brown wire in car) coming from.tailights. And on you headunit you will have input for reverse plug, and recerse triger wire. Conect the red wire from t...

Im sorry, it was mine mistake. Remove the trim below the glass, you know the plastic one. Then run the wire from there up, and folow the side of the glass and Bob is ur uncle. I think that wpuld look stealth enough.

It carries wires for third brake light and i think a tube for windshield washer fluid. I wouldnt damage the boot cause it might cause water leaking into the car. I would fish the wire thru the round metal hole that holds the plastic cover trim, then thru the rubber boot inside the cabin. Just forget...

On the left side you have a rubber booth, forget one clip and fish it thru there

Are you sure, you should unscrew couple of torx t20 screws

If it has working traction control than you have g85 sensor

I've just been checking the PR codes and the car has 1AT. According to the decoder I've found, this means the car has ESP, however the off button on the dash doesn't say ESP :? Does your car have G85 sensor? When you turn the wheel.does the value change? On a slippery road, just mash the gas pedal,...

Sand with 600,800,1000,1500,2000 wet grit paper, then use 3M green cap and polish with a drill attachment ( foam or wool pad will do the job)

Damn i tought it was a scratch ahahahahhaha

FAIL

Yeah subframe needs to come down, and right axle. I will be removing dpf on mine and remapping it soon. Flex pipe.is cheap ~15 Eur

What about fuse values, do they need to go up?

Maybe your wires are wrong. Do you have diagrams for pinouts?

I dont think that you need one, these cars are pretty stiff from the start

For the key part it pretty easy, just find a key with 3 buttons, id 48, 434 Mhz, you can get a new one for 9$ and the quality is top notch. Just transfer your immo chip from the basic key, shave the plastic layer by layer, take your time it takes about 15 min with a unility knife. And just use some ...

Bent wheel?

But start stop system requires non standard battery as i know