UK-POLOS.NET - THE VW Polo Forum

Dear,
Actually the reading was related to pedal position sensor, and the car is not drive by wire system. However, the PPS doesn't result an intermittent engine stalling. Today I am checking the immobiliser, my guy suggested to reprogram it and is requesting a code. What's weard is the mobil. Light ...

Oh one thing I forgot; once it stalls by itself it doesn't start unless battry reset, waiting for it fore for more than 20 min. Or disconnect the spark plug fuse (#37).
The stalling makes the fuel pump shutoff and ignition system out of power. When I disconnect the fuse (#37) and connect it back, I ...

Thanks Alex, it took me a while dealing with diff. Things.
Problem: It starts and run for one...two minutes and engine shuts on idling no matter what temperature it has unless I press the pedal.
Fault codes: there were 18041, 18047, 18088 and 18556 a while ago. After cleaning the throttle body ...

Thanks for the correction (MAP), yes I will swap the CTS and today I have learned that it had some fault codes related to acceleration pedal low signal ( 18041 and 18047) but cleared a while a go. We re scan it to verify and it is not there anymore.
I have read that some one with same fault codes ...

Hello dear,
Thanks for your input. For your info, we have clean up the throttle body with carb cleaner and jerking idle has gone. So it is working well. Our altitude is about 2300 a.s.l. it has low pressure if it has any effect. But it was well working for more than s year.
I assume that if MAF or ...

Thank dear for your suggestions.
It has been two years since I started to drive the car and was running well. I took it to a garage to make a scan and come up with no error codes . It has an immobiliser which is in a good condition. We checked compression and resulted (> 140 per cylinder) which is ...

alexperkins wrote: Sat Jun 20, 2020 10:13 am Glad you fixed it. That’s an unusual issue!

Dear Alex, I have polo iv 1.2 9n, 2004 and is stalling at low acceleration at traffic ... could you please give me any idea where to check.
Thanks

:( I guss some one will enlighten me with info.
I have polo iv 1.2, 40k (9N) 2004 made and is troubling me by stalling after the engine started and run for couple of seconds. I have replaced fuel filter, checked the fuel pump, relay is okay, ignition coils are okay, spark plugs changed and okay ...