UK-POLOS.NET - THE VW Polo Forum

Well, after having installed the automatic light sensor and having tried it, I must say that it works very well, the only downside is in the garage that since the lights are on when you get in or out of the car, it gives the acoustic warning of lights on, the best solution that I have found is when ...

Do you know if with this BCM I could retrofit some OEM automatic lights?

Thank you very much for the answer, and is it complicated to install with OEM parts? Any tutorial available on the forum?

Hello, I would like to install automatic light sensor in my Volkswagen polo 6r, what is the best way to do it? I've searched the forum but I can't find any tutorial on how to do it. I have seen this kit that is removable and put, has anyone tried it? I guess they will not be of good quality for the ...

I got confused, it is not an RCD330, it is an RCD 440PRO, I have the RCD330 in Volkswagen Passat b7

...today in a two-hour trip has left my battery at 100%. Were you pressing the accelerator harder :? ? More seriously, were you using a different charging lead? Some will allow the phone and charging port to negotiate a faster charge strategy. I have a super little Belkin "wall wart" that...

I have already done my first trip with the cruise control and it works great. :D A curiosity, I have an RCD 330 radio installed in the Volkswagen polo which works very well and has Android Auto with a cable connection, the only bad thing about it is that it hardly charges my mobile battery even if i...

SOLVED! I have erased the faults and with a new scan I no longer see any errors! Yesterday when I verified the entire installation I improved the union between the yellow/black cable and the blue/black cable and then I did the scan without erasing the faults, so I guess that's where the error was, a...

1) I have verified the continuity between t73a/44 and t6/4 with a multimeter.

2) I have verified the continuity between sb11 and t6/4 with a multimeter.

3) I have connected the original fuse to sb11, the autoscan is exactly the same as the previous one I sent. There has been no cruise control fault.

The fuse holder is connected to the cable of the kufatec tempomat kit that can be connected to t73a/44.

To do the new scan, do I remove the cruise control coding from VAGCOM? or do I keep it activated?

Where is the T6 connector located?.

ciclo wrote: ↑Fri Sep 02, 2022 12:35 pm

this is sb11b?



this measurement I get:

iichel wrote: ↑Fri Sep 02, 2022 12:09 pm No the circled t17/4 is to the stalks to operate the high beam switch. T17/1 (black) is +15

What should be my next step?

Check continuity between t17/4 and t73a/44?.

Directly join black/yellow cable to t73a/44?.

I have disassembled the light control connector, should there be continuity between this cable that I mark with the red circle and t73a/44?

I put photos, right now the installation consists of an extension of the yellow/black cable with a small black/blue cable. I have joined these two cables with a connector that I had left over and it is very well protected with tape. The black and blue cable is connected to 73a/44 with the specific c...

It detects the 4 buttons well for me if you refer to this measurement.