Airbag problem after new steering wheel

Discuss In Car Electronics / Electrical Systems - use with caution!
Post Reply
mdxspecial90
New
Posts: 2
Joined: Mon Oct 17, 2016 9:38 pm
Drives: polo 6r
Location: italy

Airbag problem after new steering wheel

Post by mdxspecial90 »

Hi dears!!
i have a BIG problem with my polo... i install a new steeringwheel, this one in picture:

Image


it's fantastic, before this i had not steering wheel commands, but with two wires i resolved the question.
after install, i had airbag error light, and i try to remove it with my vag com, but nothing happen: i recived the error "airbag igniter resistence too low" :roll: :roll:
what can i do? i change only airbag and steering wheel, not my clock ring...
new airbag has this connector

Image

and this is my standard clock connector...

Image




i'm pretty sure that airbag is not fault. ( and sorry for my bad english..... )
any idea? help.. :mrgreen:
joe6
Bronze Member
Posts: 246
Joined: Mon Aug 22, 2016 5:24 pm
Drives: Golf Mk6 GTI (Scirocco gone) Polo 6c GTI
Location: East Midlands

Re: Airbag problem after new steering wheel

Post by joe6 »

As you did not have a MFSW before you will need a new airbag and airbag wiring loom. See this link viewtopic.php?f=10&t=54171
mdxspecial90
New
Posts: 2
Joined: Mon Oct 17, 2016 9:38 pm
Drives: polo 6r
Location: italy

Re: Airbag problem after new steering wheel

Post by mdxspecial90 »

joe6 wrote:As you did not have a MFSW before you will need a new airbag and airbag wiring loom. See this link viewtopic.php?f=10&t=54171
hi dear, the problem is that i alredy have right airbag and i had put the other 2 wires..! :( i wish it's the clock spring...
Post Reply