Hi guys,
I want to install OPS 8k system for my polo 6c 2015.
Following this diagram:
Where is the point "B390"? and what's the nearest point CAN signal (high/low) to the trunk?
Thank you..
From where take the CAN signal (+/-) [Polo 6c 2015]
- iichel
- Bling Bling Diamond Member
- Posts: 6368
- Joined: Fri Nov 14, 2014 2:14 pm
- Drives: Polo 6R 2.0 TDI, Passat B8 2.0 TSI
- Location: http://mypassat.nl/
Re: From where take the CAN signal (+/-) [Polo 6c 2015]
I would say, there is none very close to the rear. Since you're doing 8K pdc, front and rear, you might as well get it from i.e. engine ECU or BCM or AFS module (if installed). Other options are airbag ECU or power steering.
-
- New
- Posts: 35
- Joined: Fri Jun 29, 2018 9:25 pm
- Drives: polo 6C trendline 1.6mpi 2015
- Location: Algeria
Re: From where take the CAN signal (+/-) [Polo 6c 2015]
then, I'll take it from the BCM (J519) T73c: 44/45.
But in reality, what do the points B390 B383 mean ?
But in reality, what do the points B390 B383 mean ?
-
- New
- Posts: 35
- Joined: Fri Jun 29, 2018 9:25 pm
- Drives: polo 6C trendline 1.6mpi 2015
- Location: Algeria
Re: From where take the CAN signal (+/-) [Polo 6c 2015]
Is there a CAN signal on the 5F module (infotainment system), and is it compatible with my case?
- iichel
- Bling Bling Diamond Member
- Posts: 6368
- Joined: Fri Nov 14, 2014 2:14 pm
- Drives: Polo 6R 2.0 TDI, Passat B8 2.0 TSI
- Location: http://mypassat.nl/
Re: From where take the CAN signal (+/-) [Polo 6c 2015]
Yes there is a signal but it's not the correct can network
-
- New
- Posts: 35
- Joined: Fri Jun 29, 2018 9:25 pm
- Drives: polo 6C trendline 1.6mpi 2015
- Location: Algeria
Re: From where take the CAN signal (+/-) [Polo 6c 2015]
Is there CAN wires behind the "glove box" for passenger airbag?
How about this ( blue plug top image)?
How about this ( blue plug top image)?
- iichel
- Bling Bling Diamond Member
- Posts: 6368
- Joined: Fri Nov 14, 2014 2:14 pm
- Drives: Polo 6R 2.0 TDI, Passat B8 2.0 TSI
- Location: http://mypassat.nl/
-
- New
- Posts: 35
- Joined: Fri Jun 29, 2018 9:25 pm
- Drives: polo 6C trendline 1.6mpi 2015
- Location: Algeria
Re: From where take the CAN signal (+/-) [Polo 6c 2015]
Where is the airbag ECU please?
- iichel
- Bling Bling Diamond Member
- Posts: 6368
- Joined: Fri Nov 14, 2014 2:14 pm
- Drives: Polo 6R 2.0 TDI, Passat B8 2.0 TSI
- Location: http://mypassat.nl/
Re: From where take the CAN signal (+/-) [Polo 6c 2015]
It's below (all the way on the floor) if you go down from the climatronic/radio panel.
-
- New
- Posts: 35
- Joined: Fri Jun 29, 2018 9:25 pm
- Drives: polo 6C trendline 1.6mpi 2015
- Location: Algeria
Re: From where take the CAN signal (+/-) [Polo 6c 2015]
Can you show me a picture?