Trust me, I'm a large fellow and my hand, fingers, neck and back hurt like h*ll.
But once you start this adventure (started this BCM swap simply for MFSW retrofit) you simply cannot stop
And I did it one part at a time, first just the BCM, then some power signals, then low beam, etc.etc.
so I spread it over a long period of time (also because of some health issues) ..
But now since it's finished it gives a good feeling.
And because it's my wife's UP ... if the wife is happy, everyone is happy
Respect to the support from this forum as well.
I couldn't have done (and wouldn't have known all this) without it!
Thanks again,
H2Deetoo
some errors after upgrading 1S0937087D bcm to 1S0937090F
- iichel
- Bling Bling Diamond Member
- Posts: 6368
- Joined: Fri Nov 14, 2014 2:14 pm
- Drives: Polo 6R 2.0 TDI, Passat B8 2.0 TSI
- Location: http://mypassat.nl/
Re: some errors after upgrading 1S0937087D bcm to 1S0937090F
Perhaps we should do a meeting sometime, lol.
-
- Getting There!
- Posts: 96
- Joined: Sun Oct 27, 2019 3:43 pm
- Drives: VW UP/Passat B6
- Location: Nederland
- Contact:
Re: some errors after upgrading 1S0937087D bcm to 1S0937090F
When you finish a bcm max retrofit in that UP we'll meet
-
- New
- Posts: 1
- Joined: Fri Feb 17, 2023 6:32 pm
- Drives: N/A Up
- Location: Bristol, UK
Re: some errors after upgrading 1S0937087D bcm to 1S0937090F
Hi, I have a 2015 VW High Up.
I'm going to have the BCM swapped to accommodate Cruise Control.
The car already has a clutch switch. Also has the hill start assist and TPWS. The headlight switch is the large connector type.
I do not wish to have auto lights.
The BCM currently in my car is 1S0 937 086D and the one I will be having installed is 1S0 937 090D
Please let me know if there are any additional changes that will need to be made to my car
I'm going to have the BCM swapped to accommodate Cruise Control.
The car already has a clutch switch. Also has the hill start assist and TPWS. The headlight switch is the large connector type.
I do not wish to have auto lights.
The BCM currently in my car is 1S0 937 086D and the one I will be having installed is 1S0 937 090D
Please let me know if there are any additional changes that will need to be made to my car
- iichel
- Bling Bling Diamond Member
- Posts: 6368
- Joined: Fri Nov 14, 2014 2:14 pm
- Drives: Polo 6R 2.0 TDI, Passat B8 2.0 TSI
- Location: http://mypassat.nl/
Re: some errors after upgrading 1S0937087D bcm to 1S0937090F
About the same as described in this topic.dltpring26101996 wrote: ↑Fri Feb 17, 2023 6:41 pm Please let me know if there are any additional changes that will need to be made to my car