Page 1 of 1

Retrofit Automatic Light control

Posted: Wed Sep 11, 2019 3:15 am
by larcho
I own a 2019 Polo Comfortline fabricated in Brasil, I know a few components are probably different from the Euro version but I'm thinking there shouldn't be too many differences. I'd like to add automatic light control to my Polo.
I've seen a lot of these aftermarket solutions that come with an integrated light sensor, but I'd like to go to something more factory set:
I checked my light switch knob and it seems it's the older/classic kind of switch with the big connector, which makes me believe the lights are not controlled by the BCM, so for starters, I need to upgrade/move the lights to be controlled by the BCM, is this even possible?

Thanks in advance!

Re: Retrofit Automatic Light control

Posted: Wed Sep 11, 2019 3:00 pm
by larcho
Just to shed some more light to my current situation. My BCM model number is: 2QW937090A, fabricated in Mexico, I assume these are used throughout South America.
The 090 at the end gives me a bit of hope as it's of my understanding that the 90 there should stand for the most equipped version. BUT I notice that the 3rd socked (C) is not connected and empty (without pins).

By the way, I just found this post: https://www.team-bhp.com/forum/diy-do-y ... alled.html he seemed to successfully move the light control to the BCM. Does Ciclo still provide wiring support?

Re: Retrofit Automatic Light control

Posted: Wed Sep 11, 2019 5:44 pm
by OomStu_ZA
I'd like to assist but cannot, sorry. At least there is one reply :)

Re: Retrofit Automatic Light control

Posted: Wed Sep 11, 2019 6:07 pm
by albob
is this thread any good to your ??


viewtopic.php?f=41&t=73355&hilit=automatic+light

Re: Retrofit Automatic Light control

Posted: Wed Sep 11, 2019 7:30 pm
by larcho
albob wrote: Wed Sep 11, 2019 6:07 pm is this thread any good to your ??


viewtopic.php?f=41&t=73355&hilit=automatic+light
Just read there that Ciclo doesn't fabricate the wirings anymore :(