![Mr. Green :mrgreen:](./images/smilies/icon_mrgreen.gif)
Maybe you should look for LED bulbs with control units (control units will avoid diagnostic failures).
Wait, I'm going to take some photos of ones that I bought a long time ago but haven't installed yet ...
You are absolutely right!with the confinement and now the hot weather (40ºC in the shade) I am not very motivated to install them
Code: Select all
1 Fault Found:
03156 - Sensor for Anti-Theft System (G578)
004 - No Signal/Communication
Freeze Frame:
Fault Status: 01100100
Fault Priority: 2
Fault Frequency: 1
Reset counter: 1
Mileage: 107865 km
Time Indication: 0
Date: 2030.14.26
Time: 00:25:52
Electrically they are plug and play. No problem.Franciswat wrote: ↑Tue Jul 28, 2020 7:44 pm Thank you for the pictures those lamps looks great.![]()
How do you think to mount them on H7 socket? Is there an adaptor?
Is there enought space for central unit inside the headlight to not modify the cap?
Problem was caused by a detached wire. Now It works like a charm.
I'm sure you will post results on your topic. I'm very curious to see the result.I have not installed them yet, I cannot 100% affirm anything
Great, thanks!In a couple of months I will be testing these LED lamps for the SCLs, at the end of August I have the ITV (MOT).![]()
I have just asked firegrafik who told methe connection must be established to Can Powertrain.
As long as you understand I have to connect emulator wires to new CAN line of BCM max in t32/28 and t32/29 instead of the old CAN line (power train)?Can emulator should be connected to the same CAN bus as instrument cluster. If you have BCMmax with extended can wires for the cluster so the CAN emulator should be there too.
What does it mean guys?try to connect to the wires Can bus about amplifier helm