UK-POLOS.NET - THE VW Polo Forum

Yes, based on what you have now

You might have to pop the housing off though. The RCN210 has a strange fakra fitting

Yeah, I searched a lot and I didn’t find the connector for the rcn. I hope it will fit


Sent from my iPhone using Tapatalk

Normally the RCN has a normal single fakra plug. Id be surprised if the one you have ordered came with what was pictured as its uncommon

Sorry but I don’t understand which one I need because there is more than one type of fakra


Sent from my iPhone using Tapatalk

order the one you pictured

Thank you very very much I’m really appreciate it


Sent from my iPhone using Tapatalk

late to the party
I have the rcn 210
The silver connector on the rcn210 where the aerial goes just pulls off and the adapter that Orel posted with the blue plug goes straight on
Hope this helps
I can post a picture tomorrow if it helps

alexperkins wrote:180 ohm resistor on the open wire in line with the blue/white wire you have already connected the lock wire to

See the last two pages

http://f.shortnd.it/ukp/vw_polo.pdf

Just now had the time to install the resistor and it’s working!! Thank you !!
And what about the windows? Which wire I need to plug?



Sent from my iPhone using Tapatalk

alexperkins wrote: ↑Wed Jan 30, 2019 11:25 am You can normally pick the wire up from the loom going near the bonnet pull that runs down along the drivers side footwell

Hi . Sorry for dragging this thread back up. I'm pretty basic at my wiring knowledge and skills . But I'm about to throw a universal eBay key fob kit in my 2 door . The haynes manual says there is a high and low coming from the door lock module am I to assume that's the wrong place for me to be looking at wiring in my new Central locking unit . I know about placing the resistor in line but my question is do I place the unlock and the lock wire to the single wire just having one directly soldered to the wire and the other soldered to the resistor then to the wire. ? The rest is basic enough for me to understand just not getting the part regarding placing the resistor to either unlock or lock wire then to the blue and white wire from the car. Any help would be so greatly appreciated. Thank you
Dave

Both to the same wire. One with the resistor inline, one without as detailed above