UK-POLOS.NET - THE VW Polo Forum

92 rocks wrote:crank sensor

Your the second person to mention that. But diagnostic didnt return any errors, so will be a gamble to replace it. How much is it to replace?

shudent be be much as it is only a sensor.

VAG COM report. Note the memory error. does everyone get this?

VAG-COM Version: Release 311.2-N


Chassis Type: 6N2 - VW Polo
Scan: 01,02,03,08,15,17,19,25,35,41,45,46,55

Address 01 -------------------------------------------------------
Controller: 036 906 033 A
Component: 1.6l/4V SIMOS3 00HS3148
Coding: 00031
Shop #: WSC 00788
No fault code found.

Address 03 -------------------------------------------------------
Controller: 6X0 907 379 C
Component: ABS/EDS 30 IE CAN V004
Coding: 15603
Shop #: WSC 00788
No fault code found.

Skipping Address 15-Airbags

Address 17 -------------------------------------------------------
Controller: 6N0 920 904 K
Component: KOMBIINSTRUMENT BOO V05
Coding: 00444
Shop #: WSC 00773
No fault code found.

Address 19 -------------------------------------------------------
Controller: 6N0 909 901
Component: Gateway K<->CAN
Coding: 00022
Shop #: WSC 00000
No fault code found.

Address 25 -------------------------------------------------------
Controller: 6X0 953 257
Component: IMMO 0003
Coding: 00001
Shop #: WSC 00000
WVWZZZ6NZYY559297 VWZ1Z0X0220786
No fault code found.

Address 45 -------------------------------------------------------
Controller: 6N0 951 171
Component: Innenraumueberw. 0002
1 Fault Found:
65535 - Internal Control Module Memory Error
00-00 - -

Address 46 -------------------------------------------------------
Controller: 6N0 959 799
Component: 7E Zentral-SG Komf. 0001
Coding: 04096
Shop #: WSC 00788
No fault code found.

Address 55 -------------------------------------------------------
Controller: 6N0 941 273
Component: Leuchtweiteregelung X17
Coding: 00002
Shop #: WSC 00788
No fault code found.

End -------------------------------------------------------

Another thing. what are the performance differences between

1. R Reg 6N 1.4 16v 100bhp Polo

vs

2. W Reg 6N2 1.6 16v 125bhp Polo?

Sounds like it might be the Lambda sensor does it idle roughly too?
the bit thats throwing me a bit is it's worse when it's raining, that sounds like water getting into the electrics. it should run better when the air is moist, (better combustion) mmm does sound like the lambda, and it's not always picked up on the checks either..

ticki wrote:Another thing. what are the performance differences between

1. R Reg 6N 1.4 16v 100bhp Polo

vs

2. W Reg 6N2 1.6 16v 125bhp Polo?

1 = 0-60 in 10.2 secs, 117mph top speed
2 = 0-60 in 8.4 secs, 127 mph top speed

forgotten the torque figures

How many Lambda sensors are their on the GTi?

What does 'Innenraumueberw' mean?

This might be daft to mention but this has only occured since you had the exhaust fitted. could they have effected the Lambda in anyway?:-s

Ah i forgot to mention this. On Sunday i found one of the six wires to going to lambda senor was snapped. I repaired it. I then got VAG COM off my mate, and got the error i posted earlier 65535. Tonight i dissconnected the battery for 30mins. took the the car for a drive, made another reading, and VAG COM found no errors.

I will see how it goes. Im concerned the fact I have used something to join the wire might change the resistance in the wire, therefore give incorrect reading.

fingers crossed.

VAG-COM Version: Release 311.2-N


Chassis Type: 6N2 - VW Polo
Scan: 01,02,03,08,15,17,19,25,35,41,45,46,55

Address 01 -------------------------------------------------------
Controller: 036 906 033 A
Component: 1.6l/4V SIMOS3 00HS3148
Coding: 00031
Shop #: WSC 00788
No fault code found.

Address 03 -------------------------------------------------------
Controller: 6X0 907 379 C
Component: ABS/EDS 30 IE CAN V004
Coding: 15603
Shop #: WSC 00788
No fault code found.

Skipping Address 15-Airbags

Address 17 -------------------------------------------------------
Controller: 6N0 920 904 K
Component: KOMBIINSTRUMENT BOO V05
Coding: 00444
Shop #: WSC 00773
No fault code found.

Address 19 -------------------------------------------------------
Controller: 6N0 909 901
Component: Gateway K<->CAN
Coding: 00022
Shop #: WSC 00000
No fault code found.

Address 25 -------------------------------------------------------
Controller: 6X0 953 257
Component: IMMO 0003
Coding: 00001
Shop #: WSC 00000
WVWZZZ6NZYY559297 VWZ1Z0X0220786
No fault code found.

Address 46 -------------------------------------------------------
Controller: 6N0 959 799
Component: 7E Zentral-SG Komf. 0001
Coding: 04096
Shop #: WSC 00788
No fault code found.

Address 55 -------------------------------------------------------
Controller: 6N0 941 273
Component: Leuchtweiteregelung X17
Coding: 00002
Shop #: WSC 00788
No fault code found.

End -------------------------------------------------------

Innenraumüberwachung is the full translation which means : Interior monitoring

So Innenraumueberw is something alone the lines of this..

Mike wrote:Innenraumüberwachung is the full translation which means : Interior monitoring

So Innenraumueberw is something alone the lines of this..

hmmm, like alarm systems?

Could the cam belt have slipped and messed the timing up.......when was it last changed

Mike_M wrote:Could the cam belt have slipped and messed the timing up.......when was it last changed

2006 55K iirc

mileage now 88K

chrischap2003 wrote:This might be daft to mention but this has only occured since you had the exhaust fitted. could they have effected the Lambda in anyway?:-s

na it was like that before hand,

PS fancy another mini meet sometime?