Page 4 of 4
Posted: Thu Jul 22, 2004 12:22 pm
by Karl_CLCoupe
Tahrey1043 wrote:i didn't know all the polo modders were norvun taipes, i thought it was all saafen
They may be northern, but I'm on my todd up here in Southport. Theres no one closer than Manchester, and I'm one of 2 modified Mark3s in the area. The other one is another white 1.3 CL, but hes gone down the meshed grille, big exhaust route. Anyone fancy moving to Southport? House prices are reasonable, many seaside ammenities... No? didn't think so
Karl.
Posted: Thu Jul 22, 2004 8:20 pm
by DanW
Karl_CLCoupe wrote:Tahrey1043 wrote:i didn't know all the polo modders were norvun taipes, i thought it was all saafen
They may be northern, but I'm on my todd up here in Southport. Theres no one closer than Manchester, and I'm one of 2 modified Mark3s in the area. The other one is another white 1.3 CL, but hes gone down the meshed grille, big exhaust route. Anyone fancy moving to Southport? House prices are reasonable, many seaside ammenities... No? didn't think so
Karl.
move down south ya skallie! and then u can come to bvf and play around with the wicked country roads
Posted: Thu Jul 22, 2004 9:40 pm
by hardhitter
How about a rolling road day in the midlands ? That means nobody has an excuse not to go ? If there is enough people interested i could enquire to a few places.
Posted: Thu Jul 22, 2004 10:03 pm
by DanW
and prices, lol I'm skint at the mo, how much do u reckon it would cost? Plus I need to get the motors internals testedt out and cleaned out, need to go find some carb cleaner.
Posted: Fri Jul 23, 2004 4:36 am
by Tahrey1043
I'd have to get me hands on an induction kit and de-cat pipe first..... then have two goes, one without mods (be first on
), spend a while fitting that stuff, and go again at end of day to see how many mousepower it adds!
((i'd hog it all day pissing about with different bits and throttle settings etc if i could get away with it... how much does a dynamometer cost to buy?
))
Posted: Fri Jul 23, 2004 11:57 am
by concept-e
because then it would just get more confusing!
PAUL/Steve
or is it....
STEVE/Paul
we will never know!
PS found in one of my old PVW magazines a polo shoot out rolling road day!
with GT's and G40s!
Posted: Wed Aug 04, 2004 12:13 am
by concept-e
hardhitter...
get the rolling road day sorted mate! id drive to the midlands to put mine on the rollers and to meet some of you lot!
just not too far tup north!
PAUL
Posted: Wed Aug 04, 2004 6:12 am
by Tahrey1043
right o i want to ask this as i seriously havent a clue but yams interested loik
whats the outlay for a spin on the rollies? i assume it doesnt come for free after all!