Page 7 of 7
Re: Cupra sold, Progress thread - Z3M
Posted: Sun Mar 21, 2010 7:50 pm
by shantybeater
haha i need dish!!
as they are custom 3 piece the barrels are only 6" so the rears will have 6" of purrrre dish
they need to make the OEM rears look feeble and skinny!
Re: Cupra sold, Progress thread - Z3M
Posted: Sun Mar 21, 2010 7:55 pm
by Tim_GTi
What kind of tyre would you require for them then?!
Re: Cupra sold, Progress thread - Z3M
Posted: Sun Mar 21, 2010 8:04 pm
by shantybeater
No idea lol! the standard rears are 9" which run 245/40/17. I plan on a bit of stretch but not too much
Re: Cupra sold, Progress thread - Z3M
Posted: Thu Mar 25, 2010 11:07 pm
by BIG RHYS
Just had a little read and 12J rears goin be insane .. cant wait to see them on the car
Re: Cupra sold, Progress thread - Z3M
Posted: Sat Mar 27, 2010 10:16 am
by shantybeater
Re: Cupra sold, Progress thread - Z3M
Posted: Sat Mar 27, 2010 11:39 am
by Tim_GTi
Looking good.
LMs?
Re: Cupra sold, Progress thread - Z3M
Posted: Sat Mar 27, 2010 12:13 pm
by shantybeater
Bingo well done Tim
Here's one after a bit of polishing:
Custom 3 piece 19x8.5" LM's ET9&13 with Image/Schmidt 2.5" Lips & 6" Barrels
The current lips have too many holes (because they are originally for Image/Schmidt rims) but the new ones will be drilled with the right number, if I decide to make use of the current lips on the front i'll use the inserts from fake LM's, I doubt they will fit because of the low offset though.
If anyone has any standard 19" LM's and wants more dish & a low offset for the rear drop me a PM as i'm after two standard barrels to get a high offset up front.
Already on the shopping list: 5.5" lips for the rear to make 11.5's and new bolts all round