Thanks, ciclo.
Here's the thing.
I have run Ravenol VST 5W-40. Great oil. High consumption at the start.
I have run Ravenol VMP 5W-30. Also great oil, less consumption.
My intervals are about 8000km to 10000km. It depends if I can afford the oil change when the time comes.
The VST has much higher TBN number which is good for my fuel. The VMP is lower, but I ran it see if it made a difference. Plenty of extra go from the car using VMP (thinner oil), but ideally it all started consuming again around the 1000km mark after doing the oil change.
In each oil change I run Ravenol Professional Engine Cleaner as the flush.
For my last oil change, I bought some cheap 5W-40 oil and ran that for 20 minutes with the Ravenol engine flush. Then did another oil change with Shell Helix Ultra 5W-40.
I also ran CRC Intake Cleaner through it (the rubbish one, not the PEA-loaded one they don't sell here anymore).
This was the biggest change yet. No oil consumption for thousands of kilometres.
That CRC cleaner is mostly naptha, but I think it helps to remove deposits when left to soak for a bit.
The CRC GDI cleaner with high PEA content is a heck of a thing. Pity I can get it here anymore. The amount of power that came back... OMG!
Helix Ultra is produced from natural gas and that naturally has a very low NOACK number. And it's SAPS content is right for my environment too.
VMP has lower NOACK than VST, and I think Helix is there around or below VMP. And I get the thicker viscocity for my country and driving habit.
I'm not doing the catch can thing to fix the oil consumption issue (heck, I could blame that consumption partly on the leaky oil separator). I'm adding it to help with that nasty intake valve build-up of these direct injection engines. Will it disappear? No. I think these engines simulate an EGR with their intake valve timing (probably why the thing only has an intake cam phaser).
So yeah, this is classic sticky rings so typical of these. And yes, I do believe using whatever Castrol oil VW got a special deal on causes the initial problem.
My next step is to use a ester-based oil. An expensive thing. Ester-based oils are exceptionally good at cleaning. It's why even companies like Ravenol run a little in the POA-based oils, from my understanding.
I will run Motul 300V 0W-40 through it for just a 5000km cycle. It's an expensive oil, but worth a try. If you think POA is strong, look at ester.
After that, back to regular oil. I've done a weird thing with the 300V to cut the costs .. I don't want to talk about it.
So I've run oils from Ravenol (VST, VMP) and even Wolfe for a bit, and Shell Helix Ultra, the Shell has been the most impressive.
It matches or beats VMP NOACK, and possibly beats VST TBN numbers. And it definitely beats both on price, although not by much. It definitely beats them on availability. If I run low on the Ravenol it's not a simple matter of going into the nearest motor parts store and picking up a 500ml bottle while I'm out in the countryside; I have to special order. Not the case with Shell.
Look, whatever process or ritual I have done since taking over servicing from the dealership has made a massive difference.
When I had it at the dealer getting it filled with the Castrol gabagoo it was consuming 500ml per 1000km! My recent oil change only saw consumption start again after 3000-3500km and very slowly.
Also let's not forget that VW gave me back my car once with just about no oil in it.
Now the interesting thing is that I have a colleague with a 6C 1.2TSI and DSG. No care in the world given to the car, just send for a service when the light comes on. Sitting at around 160,000km and no oil consumption. It's a 66Kw or 77Kw, not the 81KW CJZD I have. Difference? It's a highway miler and not a suburb lugger like mine. There's your problem.