Page 1 of 1
headgasket quicky question
Posted: Fri Mar 18, 2005 6:34 pm
by steveo3002
ive just brought my new head gasket for the 1300 breadvan from ecp..other gaskets ive replaced have TOP printed on one side, the new one has no markings except a number stamped into one side
anyone know if theyre sided?? please only answer if you KNOW for sure, i cant afford mistakes
Posted: Fri Mar 18, 2005 7:44 pm
by ste mk1lx
yes they are sided there should be an oval looking hole this sit's on the bottom left hand side (you standing in front of the car) the alternator mounting side
Posted: Fri Mar 18, 2005 8:53 pm
by steveo3002
okay thanks
Posted: Sun Mar 20, 2005 5:40 pm
by mk2keel
It will only fit on 1 way round.
Posted: Sun Mar 20, 2005 10:29 pm
by steveo3002
okay ive fitted it now...not totaly convinced its cured the leak 100% , i can see a very very slight trace of oil on the edge of the head ..im hoping its a drip ran down from somwhere ive spilled a drop
seems to go a bit better now though...old gasket wasnt too bad, the head was slightly starting to corode near the oil drain in the front corner so i cleaned it all up well
no bore wear at 146k...and very little carbon
