UK-POLOS.NET - THE VW Polo Forum

i had a slight weep from the front driver side headgasket, so i changed the gasket and did a nice job , cleaned it all spotless and torqued up the new bolts as per the manual

now..its leaking from the front middle...quite a bit

any ideas..spose the head is warped,although if it wasnt before it shouldnt be now

is the oil gallery around that area pressurised or just a return


btw...i used a ecp gasket, maybe i shouldve got a better quality one????

sounds like warping

should have got the head skimmed if it was leaking in the first place.

doin mine at the moment but i'm getting it skimmed a bit extra to raise the compression

More pick up and go here we come mwahahahahahaha

Phoenix wrote:should have got the head skimmed if it was leaking in the first place.

doin mine at the moment but i'm getting it skimmed a bit extra to raise the compression

More pick up and go here we come mwahahahahahaha

It's always a risk putting a head back on without skimming and besides a skim ups the comp ratio and that means more power

Don't go mad tho find out what the deck height is and go to - 20 tho of that

lol i'll go as low as i can the sooner i blow it up the sooner the H section rods, forged pistons and steel crank go in.

Mwahahahaha bring on the nitrous and nurburgring

Phoenix wrote:lol i'll go as low as i can the sooner i blow it up the sooner the H section rods, forged pistons and steel crank go in.

Mwahahahaha bring on the nitrous and nurburgring

Oh you won't have to worry about blowing it up just the pistons tapping on the cylinder head at then end of every stroke

Still you can just say it's a diesel

i'll try to get as close as i can but i won't go so low that they hit, lol i'm not that mad

Phoenix wrote:i'll try to get as close as i can but i won't go so low that they hit, lol i'm not that mad

^ three posts up + 10 thou is max but you have no more room for another skim so the head is scrap if the gasket ever blows

I'm still looking for a 1.3 Coupe S head with Hyd lifters - no one anywhere so it's a shame to trash a good head with no reason

well the heads never been off the car till i took it off today

so i'll do a normal skim then just see whats left but i dobt its warped as it didn't run hot, the gasket has blown out the back rather thank between the oil ways and water ways. so the cars runs fine but it just pisses oil all over the ennine bay.

Only good side is the engine bay will never rust now

bstardchild wrote: I'm still looking for a 1.3 Coupe S head with Hyd lifters - no one anywhere so it's a shame to trash a good head with no reason

There have been a couple of coupe s's being broken on porka recently.. worth a look maybe.