UK-POLOS.NET - THE VW Polo Forum

right, im after a gt when my car is sold (soon) i think the 1st thing i will do is paint the steelies black for now and slam it to the ground,
how low can it go without damaging it and where can i get kits from?
plus for the engine im thinkning...
de-cat full s/s zorst
ind kit
chip of some sort
maybe cam


one last question... how can i make it a single wiper conversion?

sorry for the questions but would be apreciated if answered.

The standard steels are black, lol.
You might get away with lowering 70mm depends where your going to drive it. Loads of places sell suspesnion.

captain_starlet wrote: plus for the engine im thinking...
de-cat full s/s zorst
ind kit
chip of some sort

always a good start on a gt


Probably best buying a single wiper kit,unless theres a how to guide on how to make one somewhere

yup, theres a how to guide on www.polo-gt.co.uk it uses a spare linkage from the unused wiper. it not bad not mine rocks about a bit.

For your chip I'd see either hardhitter on here or Poloace on Porka. They are two very different chips, so which one you choose would depend on what you are after from your GT.

Suspension kit wise, you can get a Venom spring and shock kit which is available in 70mm.

Induction kits... Piper X do a faom one that goes straight on (from what I believe anyway, might be best asking a GT owner though), or again, you can ask hardhitter on here.

HTH.

Karl.

Yes, I do my own induction kit and pipercross have one (which are foam and the only other readily available). I also do a chip which has been mentioned which works well, although it's no substitute for a proper remap.

I would go for something better than cheapo venom as you get what you pay for really. Something like FK, Weitek, Koni, H&R etc are good makes.