UK-POLOS.NET - THE VW Polo Forum

Does anyone know if and how the Chrome bit comes apart from the black bit?

I need them seperating so I can colour code the black plastic.

On the back of the badge, there's some plastic rivets. Just get a knife and cut the tops of the rivets.

When you put the chrome bit on, use a bit of araldite to replace the bits you cut off.

Did yours have 6 rivets as well?

Yeah, mine has six rivets on it. Just take them off using a stanley knife.

I stuck it on with some double-sided tape from halfords, about half an inch thin, and I stuck it along the VW bit on the back.

You're a life saver mate, I need to get it done by Sunday.

Now with your advice I should be able to

Cheers

Does anyone fancy buying the one I've done?

It's not 100% perfect but ask anyone who saw it at Santa Pod and they should agree that it's good enough to go on a car.

I'd say it's about 95% spot on

It's reflex silver in the centre by the way.

you should just take the black backing off and use little sticky pads to put it back on the boot lid!

shall i put it on mine tom?!

ok then maybe not

ViKz wrote:you should just take the black backing off and use little sticky pads to put it back on the boot lid!

You can't otherwise I would have done it that way.

Randall wrote:shall i put it on mine tom?!

ok then maybe not

Could do mate, it would certainly stand out

yeah you can mate done it to my motor and it NEVER fell off or even moved out of place.

think 2 members off porka can confirm it

So you took the chrome bit off the black plastic and just stuck the VW sign on the back?

This badge and more are for sale

http://www.tigerstyle.co.uk/poloforum/v ... hp?t=20933