UK-POLOS.NET - THE VW Polo Forum

Hi there folks,
Does anyone have any ideas where i can relocate my charcoal canister so i can get a decent air feed for my carbon airbox ?

Was planning on using left fog light as an airfeed the same idea as the passengers foglight thats used to cool engine/gearbox by drilling a few holes in plastic grill.

But i'm stuck as where to relocate canister as the Gti's engines bays tight for space

Was gonna use airfeed from passenger fog light but would use to much ducting pipe and look silly going down left of engine and along front of it too.

Tried to go down right of engine from throttle body but airbox is too big

Help or ideas would be good.

Cheers Guys

Anyone ideas !!!!!!!!!!!

Sorry for being dense but what is a "Charcoal Canister"?

I have my airfeed coming from behind the middle grill (VW badge one) on the drivers side. I removed the grill then drilled through the plastic to create a decent sized hole. I think this is the best option. Will try and get some pics up tomoz for you!

Mat

Ended up Just running pipe round front of engine to passenger fog light for the now.
Looks rough but you don't see it when bonnets shut



and pass side with ducting pipe going to fog from filter



Heres a pic of charcoal canister dude

I extended the hoses to the canister and made a bracket to locate it above the gearbox at the back, its therefore unseen and keeps the bay tidy. The ducting then goes to the foglight aperture.

Ah ok !!!
What kind of hose you use ?
Just normal rubber fuel hose ?

Pretty much. I work at partco so just looked for a hose of the same diameter.

Ok cheers man.

*UPDATE*

Went looking for a new air feed again @weekend to experiment, looked down left right behind grill with no sucess

So Managed to drill out a wee bit behind my grill on the right of the radiator with a big spade bit, and took a feed off that for the now

I dont think its noticable with grill on
May have to change it though as i dont think the air flow is that great
I also took GTI badge off as that was right on front of air feed, and its growing on me a bit being off

Finally decided how to set up Induction Kit guys

Went to local scrappy and managed to find a bit of plastic ducting pipe off a Mark 2 Golf for a feed.
And i just ended up using Original air feed in wing (Still has a nice note when you floor it too)








INTAKE PIPE INTO WING



INTAKE PIPE INTO WING





What you's think ?


And heres on of car with Shortened Number plate

Looking good Richard.

Check how how much smaller my plate was

Bloody hell, thats small.
Any trouble with police with it ?
I aint got pulled yet
Touch wood

Any more mods ?

Got pulled because of the spacing, so I had to change it. The one I've got now is still the same width, just a little deeper and sitting on my dashboard

Here's a couple of recent pics





The rear plate is back on now though

looking sweet
Can io ask ?
Whats the wee map below your rear Gti badge about ?

It's the Nurburgring mate, a stupidly long and dangerous track in Germany.

You usually get the sticker after doing a lap but I cheated and bought one off e-bay, I do want to go round it though.