Page 1 of 1
wheel bolts
Posted: Tue Jun 27, 2006 6:55 pm
by willriseley
right i have got some old slotmag wheels for my mk2 saloon and the studs fit but the centre bore dosnt sit on the wheel hub.there is about a 1/4 inch gap between them, is this gonna be fine to run like this?
also anyone know where to get some 10mm longer wheel bolts for the polo?
Posted: Tue Jun 27, 2006 10:59 pm
by Mk2Adam
if the center bore doesn't fit correctly then simply don't even try it, dangerous to drive on, but you can get spiggot rings which fit in there so it'll work
Posted: Tue Jun 27, 2006 11:13 pm
by SteB
I take it they're mini fitment (PCD of 4x101.6) Have they been redrilled to 4x100? If they are still mini PCD, they wont fit properly and you will end up ovaling the bolt holes
Just something to consider.
Spigots and longer wheel bolts can be obtained from Demon Tweaks.
Posted: Wed Jun 28, 2006 6:59 pm
by willriseley
i think they are like an old vauxhall fitment but the bolts line up ok. its just like a 1/4 inch gap from the centre of the wheel to the centre of the car hub. ahh well whats the worst that could happen? run it till it brakes
Posted: Wed Jun 28, 2006 8:01 pm
by Mk2Adam
haha, more likely run it till your wheel falls off going at 80 on the motorway and you die
but up to you really
Posted: Wed Jun 28, 2006 10:12 pm
by SteB
For the sake of a couple of quids worth of spigot rings, I wouldnt be risking it