Page 1 of 1
Aerial not working advice needed
Posted: Tue Aug 07, 2007 6:54 pm
by gazmangti
Changed my head unit with a new kenwood unit. Aerial didnt work before and and still doesnt
.
Got a aerial amplifier and remade of the aerial connector and checked aerial on roof. Everthing seems to be ok.
BUT i need to get to the connection on the roof inside to head lining. Dont want pull head lining down in car for obvious reasons!
Any suggestions what i can do?
Cheers
Gaz
Posted: Tue Aug 07, 2007 8:58 pm
by polo_gti21
the only way is to take the lining off its ok just pull the center trim off by the boot and gentally pull the lining down and the connector is close to the back just be gental with it, i had to replace the rubber seal on the ariel as it was good for nothing
Posted: Tue Aug 07, 2007 11:00 pm
by Tim_GTi
polo_gti21 wrote:the only way is to take the lining off its ok just pull the center trim off by the boot and gentally pull the lining down and the connector is close to the back just be gental with it, i had to replace the rubber seal on the ariel as it was good for nothing
I need to do that to, I saw a post about it on here a while back, dunno where i cud fish it out from do you?
Posted: Wed Aug 08, 2007 10:00 am
by gazmangti
Can't find much on this topic. Think i might just book it into an audio center.
Posted: Wed Aug 08, 2007 6:21 pm
by Tim_GTi
thats probably the best bet mate
Posted: Thu Aug 09, 2007 8:07 pm
by polo_gti21
taking it to a audio shop is ok but they tend to mug people off by saying that they need this and that when all they need to do is reconnect a connector i should know i used to work for a shop here in west london and i left coz this problem its a piece of p*** to do just be careful and you will be fine.
Posted: Thu Aug 09, 2007 8:11 pm
by polo_gti21
Tim_GTi wrote:polo_gti21 wrote:the only way is to take the lining off its ok just pull the center trim off by the boot and gentally pull the lining down and the connector is close to the back just be gental with it, i had to replace the rubber seal on the ariel as it was good for nothing
I need to do that to, I saw a post about it on here a while back, dunno where i cud fish it out from do you?
i cant find the post either but all that is needed to do this job is the repair kit from vag parts.com think its £10 just take the top center trim off carefully tho, pull the headlining down and disconnect the connector undo the nut and change it thats it. PM if you need anyhelp.
Ricky
Posted: Thu Aug 09, 2007 11:03 pm
by Tim_GTi
i found the thread i was looking for!!! its a sticky by josh in the DIY section, i jsut searched his name and it was one of the first posts to come up!! it won't help anything on this matter tho lol