Page 1 of 1
how much for....
Posted: Mon Apr 07, 2008 9:48 pm
by Kelk11
a new cat? mine is making an unhealthy loud noise, i understand they are quite expensive and best place to buy and have fitted?
thanks
Posted: Tue Apr 08, 2008 12:58 am
by Tim_GTi
I don't know the price of them new, but it's definitely worth searching scrappies for one
Posted: Tue Apr 08, 2008 9:38 am
by tegwin
Does it sound like its blowing, or is it rattling?
The heat shield on mine cracked off and was making an ungodly noise......A few minuits with the welder and its not going anywhere!
Posted: Tue Apr 08, 2008 9:50 am
by Kelk11
sounds like its blowing i think im probably best taking it somewhere to get checked out because there is a couple of clips missing off the centre section too. hopefully they can just mend it.
any place best to take it or the told quick fit just as good?
Posted: Tue Apr 08, 2008 10:08 am
by tegwin
If its just a hole, or some clips missing it should be fixable..
IMHO, I wouldnt bother with quickfit....Find an exhaust specialist..We have a couple around here that have all the equipment/parts to make exhausts from scratch....Might cost you a few quid more, but they stand a better chance of getting the job done properly!
Posted: Tue Apr 08, 2008 10:54 am
by loud
9 times out of 10 its the flexi-joint that goes on 6n and 6n2 cats, if you can be arsed you can buy a flexi-joint for like 20 quid and weld it in, or you can just buy a new cat. I got mine from cats-direct but their prices have gone up a bit since then...still a s**t load cheaper than buying from VW
http://www.cats-direct-shop.co.uk/two-y ... ordID=2029
Posted: Tue Apr 08, 2008 12:30 pm
by Kelk11
i hope it is the flexijoint certainly a lot cheaper then a new cat. there is a used cat on ebay for £70 but who knows how used it is, could only last a week so aint gunna bother with that. thanks loud for the info.