UK-POLOS.NET - THE VW Polo Forum

i'm selling my custom exhaust off my 16v 6n, has a nice low note but not stupidly loud, sounds just right.

its not the 70x140s which look odd, its wider than 140mm and thinner that 70mm

underside damage to the tip, large scratches and a dent. on the visible side there is a slight scuff where the bumper has rubbed

cost £150new looking for £40 collected








although it is not visible it should come out with fine emry paper

how low is your polo there? and have you had some of the rear bumper cut out to fit it? also would it be suitable for an 8v?

its prov sold now pending payment/collection. About 80mm down i'm guess as its wound to the lowest setting on the coilies without removing the helper springs.

it will fit an 8v but will require a reducer piece