Raz 1.4 TDI Progress thread
Posted: Wed Jul 30, 2008 2:46 pm
Welcome to my progress thread.
This is what my car looked like when i bought it.

first thing i did was change the grill to a gti grill


After the grill I got the red GTI piping done. Done this by taking the grill off and sticking the piping on by using a hot glue gun


I then got the honeycomb GTI bumper grills to match the top grill

The next thing i bought was the gti splitter. I bought this from a guy breaking his gti for 30 quid. Although it was VERY scratched up as he had a 60mm drop and the splitter probably got scraped badly on the floor.


So i got some sanding paper from halfords, got sanding for sooo long and this is what i ended up with



Got the primer cans out and started the primering. This was a first time ever attempt and i was so pleased with the output





after the primering did 2 coats of indigo blue and then lacquer



Fitted the GTI splitter




I then purchased some BBS rx" GTi Alloys which were in a bad state. 2 of the rims had bad kerb marks. So the refurbishing started. Called over a few guys to help out
This is what they looked like when i bought them




The Refurbishing Process


You can see the massive kerb at the bottom left of this rim

After a whole lot of sanding and filing and polishing this is how the rims turned out







For the centres, i have given them to a company yesterday called BJV engineering, he is going to get them blasted and powder coated, should have them on saturday!
This is what my car looked like when i bought it.

first thing i did was change the grill to a gti grill


After the grill I got the red GTI piping done. Done this by taking the grill off and sticking the piping on by using a hot glue gun


I then got the honeycomb GTI bumper grills to match the top grill

The next thing i bought was the gti splitter. I bought this from a guy breaking his gti for 30 quid. Although it was VERY scratched up as he had a 60mm drop and the splitter probably got scraped badly on the floor.


So i got some sanding paper from halfords, got sanding for sooo long and this is what i ended up with



Got the primer cans out and started the primering. This was a first time ever attempt and i was so pleased with the output





after the primering did 2 coats of indigo blue and then lacquer



Fitted the GTI splitter




I then purchased some BBS rx" GTi Alloys which were in a bad state. 2 of the rims had bad kerb marks. So the refurbishing started. Called over a few guys to help out
This is what they looked like when i bought them




The Refurbishing Process


You can see the massive kerb at the bottom left of this rim

After a whole lot of sanding and filing and polishing this is how the rims turned out







For the centres, i have given them to a company yesterday called BJV engineering, he is going to get them blasted and powder coated, should have them on saturday!