Page 1 of 1
6n2 Rear Lights
Posted: Sat Nov 22, 2008 7:01 pm
by trav
there in my house now
some one in the leicester area come and fit them for me?
I KNOW THERES A DIY GUIDE BUT I DONT GET IT
would prefer some one to come and do it else i'll f**k up! and i'll obviously pay you
Posted: Sat Nov 22, 2008 8:38 pm
by vw-po-low
It's easy as pie!
Trim the edges down so the lamps sit flush. Drill the middle hole out about 15mm, where the middle bolt from the lamp will sit.
On the n/s lamp swap over wires 1 and 2.
On the o/s lamp swap over wires 4 and 5.
Also on the o/s plug trim the notches off and turn the plug 180 Degrees so its the wrong way around. Would not take any longer then 30 minutes.
Rob
Posted: Mon Nov 24, 2008 10:13 am
by b-random
Rememebr mate the lights are already filed down and will sit flush enough to the bodywork, I found the guide the complete opposite to how they worked on mine, wires worked correct when they were wired up the same as the standard 6n tail lights
use some wire connector lugs
Posted: Mon Nov 24, 2008 10:51 am
by clarkson
did u manage to get them workin mate