Page 1 of 1
gear knob removal urgent
Posted: Mon Jun 22, 2009 11:23 am
by ppuaar_polosport
as above cheers
Re: gear knob removal urgent
Posted: Mon Jun 22, 2009 4:09 pm
by SimonCorrigan
hi
took mine off a few months ago to put a new gaiter on. pull the gaiter upwards and you should see a crimped metal collar round the gear knob. basically i used a small flat bladed screw driver and brute force. if you mank the collar up to much when taking it off just use a thick cable tie when replacing. once you have removed the metal collar just a hard pull and the knob comes off.
cheers
si
Re: gear knob removal urgent
Posted: Mon Jun 22, 2009 4:40 pm
by JB_UK
as above but i found the metal clip to be very hard to get off so i used a metal clipper type thing which worked a treat
Re: gear knob removal urgent
Posted: Mon Jun 22, 2009 5:28 pm
by ppuaar_polosport
cheers i made a hash of it so i need to be ordering a new one lol
Re: gear knob removal urgent
Posted: Mon Jun 22, 2009 6:20 pm
by JB_UK
a new what? if ur ordering a new metal clip u can deal without it just use a cable tie or Richbrook do a nice new silver VAG gear knob that i have
Re: gear knob removal urgent
Posted: Mon Jun 22, 2009 10:49 pm
by RITCHAT
JB_UK wrote:a new what? if ur ordering a new metal clip u can deal without it just use a cable tie or Richbrook do a nice new silver VAG gear knob that i have
the metal clip is there for a reason and should be replaced with it as the gear knob will start to revolve on the gear stick if not properely secured. You wouldn't put a hose on with a cable tie would you. for the sake of a £1 it's better to do it right
Re: gear knob removal urgent
Posted: Tue Jun 23, 2009 8:07 am
by RUM4MO
Yes, the OP should have used two small screwdrivers to ease the crimped ends open a bit - then recrimp it using blunt wire cutters or something like that. I'd be surprised if you can buy a new clip from VAG so maybe you have measured it and are sourcing it elsewhere - if so where for other peoples benefit?
Re: gear knob removal urgent
Posted: Tue Jun 23, 2009 6:43 pm
by RITCHAT
RUM4MO wrote:Yes, the OP should have used two small screwdrivers to ease the crimped ends open a bit - then recrimp it using blunt wire cutters or something like that. I'd be surprised if you can buy a new clip from VAG so maybe you have measured it and are sourcing it elsewhere - if so where for other peoples benefit?
yes you can buy from vw I had to when upgrading to gti spec I am sure it was about a quid but certainly readily available.
Re: gear knob removal urgent
Posted: Fri Jun 26, 2009 5:12 pm
by RITCHAT
Part number for the clip is N 100 811 01hope this helps 76p + vat 89p total for the sake of less than the cost of a cheeseburger do it right and yoou waist will feel better as well lol.