Page 1 of 1

What camber degree?

Posted: Tue Oct 26, 2010 2:34 pm
by MrP
Fitting my new coil-overs in the next few days, obviously I'm going cause havoc with the camber, but I have a camber gauge! yay!!

my question is, what should I be setting the front camber at? I'm thinking -1.5.. Will that be too much??

Re: What camber degree?

Posted: Tue Oct 26, 2010 2:56 pm
by 6N2 GTI 00
I personally think 1.5 will be too much, anything more than 1 degree is normally considered "too much".
1 degree would be fine though, mine was running at around 2 degrees negative when I had mine done and although it was immense handling it killed my tyres.

I got through a new set on the front in 1500 miles

Re: What camber degree?

Posted: Tue Oct 26, 2010 3:02 pm
by MrP
6N2 GTI 00 wrote:I personally think 1.5 will be too much, anything more than 1 degree is normally considered "too much".
1 degree would be fine though, mine was running at around 2 degrees negative when I had mine done and although it was immense handling it killed my tyres.

I got through a new set on the front in 1500 miles
Will I get 'scene points' and girls dropping their panties if I run what is considered 'too much' camber?

Re: What camber degree?

Posted: Tue Oct 26, 2010 3:19 pm
by 6N2 GTI 00
Probably at shows dude but not for everyday driving :P

Re: What camber degree?

Posted: Tue Oct 26, 2010 3:23 pm
by MrP
So what do I need to do to my camber to get 'scene points' and girls dropping their panties on a daily basis?

Re: What camber degree?

Posted: Tue Oct 26, 2010 3:43 pm
by emma_88
Fair enough on the 'girls dropping their panties'... But do you really want / need 'scene points?'

Re: What camber degree?

Posted: Tue Oct 26, 2010 3:46 pm
by 6N2 GTI 00
A lot of the scene peeps are Nobs to be fair

Re: What camber degree?

Posted: Tue Oct 26, 2010 3:53 pm
by MrP
Nope, I was taking the p***... I'm not rich enough (read stupid) to spend loads on my car to get enough scene points.

and as for the pants dropping, I just like girls :D

On a more serious note. Will -1.0 be good, what's recommended from a standard point of view?

Re: What camber degree?

Posted: Tue Oct 26, 2010 5:03 pm
by Bradley
I know its not in with the "Scene kids" but i thought these Specifications may help you dude.

These are the official ratings.

Front

Min: -0.83
Max: -0.17

Rear

Min: -2.00
Max: -1.34


Ive got the caster and toe for the front and the toe for the rear if you need them.

Re: What camber degree?

Posted: Tue Oct 26, 2010 10:24 pm
by MrP
Nice!!!

So I should aim for anything on between those values?

If you could get the caster/toe that would be ace!!

Re: What camber degree?

Posted: Tue Oct 26, 2010 11:41 pm
by Bradley
Yeh anything in between those two will do you well dear chap.

You'll struggle to get the toe on the rear i think but here is the info you need at least you can get it as close as.

Front

Toe
Min: -0.09
Max: 0.09

Caster
Min: 1.83
Max: 2.83


Rear

Toe
Min: 0.09
Max: 0.25


Hope thats of help to you dude.

Re: What camber degree?

Posted: Wed Oct 27, 2010 8:57 am
by MrP
Bradley wrote:Yeh anything in between those two will do you well dear chap.

You'll struggle to get the toe on the rear i think but here is the info you need at least you can get it as close as.

Front

Toe
Min: -0.09
Max: 0.09

Caster
Min: 1.83
Max: 2.83


Rear

Toe
Min: 0.09
Max: 0.25


Hope thats of help to you dude.
Love you! xxx

Re: What camber degree?

Posted: Wed Oct 27, 2010 9:04 am
by Bradley
Love you too xxx