Page 1 of 1
Cup Edition chassis to 9n 1.4 16v
Posted: Wed May 30, 2012 8:55 pm
by twin
Does Polo 9n3 GTi Cup Edition 2008 original chassis (absorbers + springs) fit to 9n 1.4 16v 55kW 2004?
Absorbers:
front
6Q0 413 031 CG
rear
6Q0 513 025 BM / 6Q0 512 011 BP
Re: Cup Edition chassis to 9n 1.4 16v
Posted: Thu May 31, 2012 8:25 pm
by yorks GT TDI
yes
Cup Edition chassis to 9n 1.4 16v
Posted: Sun Jun 03, 2012 2:15 am
by Dub_Dan
Dude why not just upgrade to some proper aftermarket shocks and springs that will actually make a difference? Are you after performance? If not I wouldn't bother wasting your time as you will hardly notice the drop or much performance increase handling wise...
Just my 2 cents...
Re: Cup Edition chassis to 9n 1.4 16v
Posted: Mon Jun 04, 2012 5:47 pm
by twin
This suspension is from Cup Edition with only 22000km on it. If there would have been anything else for less than 100€'s I would have considered something else. Had also good offer of H&R -35mm springs so most probably will update suspension with those. I'm not after performance (75 ps
) with this car, this is our "shopping bag"...