DAB Roof Antenna Replacement?
Posted: Thu May 30, 2013 9:26 am
My first post so please treat me gently. I've just bought a 2004 3dr Polo Twist for my son so I think I'm posting on the correct board?
The car has an aftermarket radio fitted and I wish to replace it with a DAB unit. Rather than use a glass mount aerial, I would like to replace the bee sting antenna with a proper DAB aerial both for cosmetic reasons and because I know this is necessary for adequate reception in my area. I have some questions I hope you can help answer.
1. I realise that replacing the antenna involves dropping the headlining and whilst I've found various written descriptions of this I can't find any pictures. Can anyone point me in the right place please?
2. I presume that some sort of plastic tool is required to pry off various pieces of trim without damaging them. Can anyone recommend something?
3. I imagine that I must route a new cable to connect the new antenna to the head unit. Is that correct? If so, how do you go about doing that?
4. The existing aftermarket head unit seems to have been fitted rather poorly. There is no AM reception (dodgy antenna?) and the head unit does not remember its settings when the ignition is switched off. I haven't looked at the plugs on the back yet but what plugs were fitted to the original wiring harness and what is the best way fitting adaptors so that it is easy to fit modern head units?
5. Are there any speakers behind the rear speaker grilles?
Many thanks in advance for all your help.
K
The car has an aftermarket radio fitted and I wish to replace it with a DAB unit. Rather than use a glass mount aerial, I would like to replace the bee sting antenna with a proper DAB aerial both for cosmetic reasons and because I know this is necessary for adequate reception in my area. I have some questions I hope you can help answer.
1. I realise that replacing the antenna involves dropping the headlining and whilst I've found various written descriptions of this I can't find any pictures. Can anyone point me in the right place please?
2. I presume that some sort of plastic tool is required to pry off various pieces of trim without damaging them. Can anyone recommend something?
3. I imagine that I must route a new cable to connect the new antenna to the head unit. Is that correct? If so, how do you go about doing that?
4. The existing aftermarket head unit seems to have been fitted rather poorly. There is no AM reception (dodgy antenna?) and the head unit does not remember its settings when the ignition is switched off. I haven't looked at the plugs on the back yet but what plugs were fitted to the original wiring harness and what is the best way fitting adaptors so that it is easy to fit modern head units?
5. Are there any speakers behind the rear speaker grilles?
Many thanks in advance for all your help.
K