Page 1 of 1
wire harness passage
Posted: Mon Apr 20, 2015 9:55 am
by alexandervf
Hi everyone,
I have a 9n and i was wondering if someone could shed some light regarding a question i have.
I need to pass two small wires from the drivers cabin/dashboard to the engine bay so that i can install a volt meter.
Can someone please tell me where to route them from.
Pics would be very helpful.
Thanks
Re: wire harness passage
Posted: Mon Apr 20, 2015 10:55 am
by alexperkins
Where is the volt meter being fed from?
Re: wire harness passage
Posted: Mon Apr 20, 2015 11:01 am
by alexandervf
From the cars main battery.
Re: wire harness passage
Posted: Mon Apr 20, 2015 11:23 am
by alexperkins
Silly question, but can you not just take the 12V feed from somewhere behind the dash?
Re: wire harness passage
Posted: Mon Apr 20, 2015 11:45 am
by alexandervf
I'd rather not....two main reasons.
1st. i m against the idea of having to chop off the main or any sub harness
2nd. the volt meter i m about to install is the ctek 56-531 where you can also plug your charger.
So, preferably, and for various other reasons i would like to take the wires direcrly to the battery.
Any idea where from can i route the wires,to the engine bay?
Alex
Re: wire harness passage
Posted: Mon Apr 20, 2015 11:48 am
by alexperkins
Fair enough - understand your reasons
The below post has it documented pretty well
http://www.uk-polos.net/view ... 43&t=51032
Normally the grommet behind the ABS pump is quite popular, but there are a few other choices.
Re: wire harness passage
Posted: Mon Apr 20, 2015 11:59 am
by alexandervf
Thanks for all the help.!