Lupo/polo driveshaft nut size
Posted: Wed Jul 20, 2016 11:50 pm
Hello, I've just put an AFH engine in my Lupo and have used one of the driveshafts as well. Fits perfectly, no issues there, but the outer nut on the hub doesn't tighten past half way through the nut. I have tried on 4 polo driveshafts now and same issue on all of them. Works perfectly on the Lupo one.
I have looked and apparently both are M20x1.5 (although confirmation would be great)is anyone aware of any differences? I understood that they were interchangeable
Thanks a lot.
I have looked and apparently both are M20x1.5 (although confirmation would be great)is anyone aware of any differences? I understood that they were interchangeable
Thanks a lot.