Page 1 of 1

Scirocco seats in a polo 6r?

Posted: Thu Jun 01, 2017 10:52 pm
by mattykenny27
Does anybody know if scirocco seats will fit into a polo 6r 2012? And is there much work required?

Re: Scirocco seats in a polo 6r?

Posted: Fri Jun 02, 2017 2:25 pm
by Willni
Probably could but would require a lot of work with the Polo you have a choice from Audi A1 and Skoda Fabia for straight fit. Apparently Passat CC seats go in but I'm not sure on fitment

Re: Scirocco seats in a polo 6r?

Posted: Sun Jun 04, 2017 12:53 pm
by mattykenny27
Thank you, gonna look into it cheers

Re: Scirocco seats in a polo 6r?

Posted: Sun Jun 04, 2017 3:06 pm
by SRGTD
Forum member D7VXD has fitted mk6 Golf GTI seats in their Polo 6r and I suspect the Scirocco seats are a similar size to the mk6 Golf GTI seats, although a different design.

Might be worth sending them a pm to find out more on what was involved in the seat swap.

viewtopic.php?f=56&t=69554&start=15

Re: Scirocco seats in a polo 6r?

Posted: Tue Jun 06, 2017 1:11 am
by mattykenny27
Thanks for the help, might be worth a try messaging him thank you!

Re: Scirocco seats in a polo 6r?

Posted: Wed Jun 14, 2017 10:56 pm
by D7VXD
Bit late but... 8)

Reckon you'd need custom rails for the front seats or you can try measure it up and modify the seat rails yourself (a lot of hassle to get it to finally fit).

I'm not sure about how the rear bench would sit but I know the golf one isn't a straight swap either.

Also connections to the loom for the airbags etc may be different, I've placed a resistor in my loom to remove the airbag light but it means the airbags in the seats won't deploy if I crashed.

So to answer the question, yes it can be done. Although it will cost a bit extra money depending on the route you take and it'll unfortunely not be as simple as unbolting your old seats and bolting in the new ones :cry:

Re: Scirocco seats in a polo 6r?

Posted: Sat Jul 15, 2017 1:12 am
by mattykenny27
D7VXD wrote: Wed Jun 14, 2017 10:56 pm Bit late but... 8)

Reckon you'd need custom rails for the front seats or you can try measure it up and modify the seat rails yourself (a lot of hassle to get it to finally fit).

I'm not sure about how the rear bench would sit but I know the golf one isn't a straight swap either.

Also connections to the loom for the airbags etc may be different, I've placed a resistor in my loom to remove the airbag light but it means the airbags in the seats won't deploy if I crashed.

So to answer the question, yes it can be done. Although it will cost a bit extra money depending on the route you take and it'll unfortunely not be as simple as unbolting your old seats and bolting in the new ones :cry:
Only seeing this now mate sorry! Cheers for the advice