Page 1 of 1
Steering angle sensor
Posted: Tue Oct 03, 2017 3:50 pm
by Cheesebrains
Can anyone point me in the direction of some instructions to reset the steering angle sensor?? Also read somewhere that it can be bypassed if it becomes a regular thing??!
Re: Steering angle sensor
Posted: Thu Oct 05, 2017 10:05 am
by alexperkins
It’s a VCDS calibration job to reset this. It can’t be bypassed either. It’s used for all sorts of things in the car
Re: Steering angle sensor
Posted: Thu Oct 05, 2017 3:37 pm
by Jay-Jay
With VCDS go into ABS Unit.
Click on "Security Access" and type "40168".
Make sure your steering is perfectly straight.
Then go into "Basic Setting", type Group "060" and click "Go". You'll see the program will inform you about the recalibration process. It will take only few seconds.
Re: Steering angle sensor
Posted: Fri Oct 27, 2017 11:29 am
by Cheesebrains
Tried through vcds to reset/calibrate this just now but says "aborted safety reasons" any ideas??
I did change the sensor for a new 1 but didn't think it needed coding or is this the reason why it's saying this??
Re: Steering angle sensor
Posted: Tue Apr 17, 2018 10:38 pm
by EdgardoRodriguez
Cheesebrains wrote:Tried through vcds to reset/calibrate this just now but says "aborted safety reasons" any ideas??
I did change the sensor for a new 1 but didn't think it needed coding or is this the reason why it's saying this??
Hello!
Have you solved this safety reasons issue ? I am through the same now..
Enviado desde mi iPhone utilizando Tapatalk