Page 1 of 1
Glovebox light retrofit
Posted: Sat Jan 27, 2018 1:57 pm
by Norbreck21a
Hi guys, in the next week or so I’m looking to do the modification of adding a light in the glovebox of the wifes 2016 Blue GT.
Just a quick question or two. Firstly I have the light already (from eBay) but need to source the correct VW wiring connector, does anyone know the part number of this please .
Secondly, where do you tap the 12v from to ensure it only works with ignition on please ?
Thanks.
Re: Glovebox light retrofit
Posted: Sat Jan 27, 2018 2:22 pm
by iichel
1x 1J0972702
i'd take the ignition live from the fuse box.
Re: Glovebox light retrofit
Posted: Sat Jan 27, 2018 3:49 pm
by Norbreck21a
Thanks iichel
Re: Glovebox light retrofit
Posted: Mon Jan 29, 2018 2:00 pm
by CNK
Re: Glovebox light retrofit
Posted: Wed Jan 31, 2018 4:32 pm
by Norbreck21a
Thanks both. One final question please. If I have to remove the discover media unit from inside the glovebox before I can remove the box itself, does this cause any issues when plugging it back in. I know in the old days, stereo units used to ask you for a Pin code to get them working again. Can I assume that the unit is already "registered" with the CAN Gateway, therefore when plugging it back in again should automatically re-activate it ?
Re: Glovebox light retrofit
Posted: Wed Jan 31, 2018 4:59 pm
by iichel
that is correct. don't worry.
Re: Glovebox light retrofit
Posted: Wed Jan 31, 2018 6:14 pm
by ciclo
- Light available since the car is opened.
- The battery will never drain in case of failure (light or switch) or by leaving the lid open when closing the car.
- BCM protection.
LHD

RHD
Re: Glovebox light retrofit
Posted: Wed Jan 31, 2018 7:08 pm
by Norbreck21a
Thanks guys