Page 1 of 1

Chaning blubs

Posted: Sat Sep 25, 2004 12:56 pm
by neilw
Ok i got my new bulbs form powerbulbs. read you gotta take the front bumper off to change them. but... how do you take it off, i took out 4 torx screws, in the wheel arch and next too the fog light, it feels like its still attached near the headlight washer. Is this just a clip or another screw, and if its a screw how do i get too it?? Dont wanna just pull the bumper off incase i damage it.

Neil

Posted: Sun Sep 26, 2004 3:42 pm
by mikegti
if you tilt the cap on the top of the headlamp washer (the way it normally pops up) then this lifts up the washer jet. then use something to hold up the washer jet whilst you take the cap off.
It not too difficult and you shouldnt break it!