Mass air flow sensor (G70) P0101 + Leak in Air Intake System P2279
Posted: Fri Oct 07, 2022 11:20 am
Hi Guys, I have had this little problem for some time now, it has always been set aside as the car runs properly and has no power loss or other strange things.
the problem occurs between 1000+ and 1500 rpm, below or above it does not occur and only with 3+ gear, with 1st and 2nd gear it does not happen.
just go down a descent with the engine brake (therefore speed 60-70khm) 3 gear engine revs within 1000-1500rpm and after exactly 10 seconds the glow light comes on with error P0101.
rarely together with it (after +10 sec above condition) the engine warning light with code also comes on P2279
Premise that:
- EGR is OFF + removed pipe from the intake manifold (plugged all right with caps and checked)
- DPF is ON
- I removed the swirls from the intake manifold (but it did it even before so this is not the problem, they were also removed from the remap + new manifold without swirl of a 2.0 tdi)
I suspect that the oil vapor recovery valve is not working properly, the steam comes out but maybe it doesn't hold tight, can it be?
I apologize for my english, thank you in advance.
the problem occurs between 1000+ and 1500 rpm, below or above it does not occur and only with 3+ gear, with 1st and 2nd gear it does not happen.
just go down a descent with the engine brake (therefore speed 60-70khm) 3 gear engine revs within 1000-1500rpm and after exactly 10 seconds the glow light comes on with error P0101.
rarely together with it (after +10 sec above condition) the engine warning light with code also comes on P2279
Premise that:
- EGR is OFF + removed pipe from the intake manifold (plugged all right with caps and checked)
- DPF is ON
- I removed the swirls from the intake manifold (but it did it even before so this is not the problem, they were also removed from the remap + new manifold without swirl of a 2.0 tdi)
I suspect that the oil vapor recovery valve is not working properly, the steam comes out but maybe it doesn't hold tight, can it be?
I apologize for my english, thank you in advance.