Toggling Polo R6 BCM output bits / VCDS
Posted: Wed Oct 19, 2022 4:48 pm
Hello everybody. Just to introduce myself, my name is Herbert and are driving a 2010 Polo R6 1.2 TDI. Retired from an international career in field engineering (electrical, electronics, power, control, drive systems, instrumentation, process plant control, etc.)
Recently during troubleshooting an electrical issue, the following question popped up:
From the PLC environment I remember that for diagnostic purposes, an output bit can be set/toggled.
I wonder whether or not this also applies to the BCM installed in my car (6R0937088D), in combination with the VCDS s/w. Has anybody experience with this?
Appreciate your support very much and thanks a lot in advance.
Recently during troubleshooting an electrical issue, the following question popped up:
From the PLC environment I remember that for diagnostic purposes, an output bit can be set/toggled.
I wonder whether or not this also applies to the BCM installed in my car (6R0937088D), in combination with the VCDS s/w. Has anybody experience with this?
Appreciate your support very much and thanks a lot in advance.