Condensation on headlights

AKs_SlickPolo · Post by **AKs_SlickPolo** » Thu Dec 22, 2005 9:10 pm

Had my 9N for 2 days now and ive noticed that it has water/condensation on the right (from the bonnet) lenses. Its for the side light/high lense mainly. Has any1 experienced this? why does this happen? and how can i get rid of the condensation without removing the lamp completely (if there is a way?!)

pls help!

dino · Post by **dino** » Thu Dec 22, 2005 9:39 pm

Sounds like there's a part of the lense not sealed fully.

Did you get any warranty with the purchase? (if brought from a garage)

AKs_SlickPolo · Post by **AKs_SlickPolo** » Thu Dec 22, 2005 9:54 pm

I did get warranty, but it only covers the mechanics, and not the lights, ABS, Aircon or Catalyst

Would this be something i could sory myself?

im thinking of removing the bulbs and then using a hair dryer to get the condensation out by poking it thru the bulb place..would this cause any damage?!?

I thought it may be seals, but from what i see, it seems fine. However, the black rubber cap on the light was slightly loose, and is the only thing i suspect that could be letting the condensation in

carmadaaron · Post by **carmadaaron** » Thu Dec 22, 2005 10:28 pm

AKs_SlickPolo wrote:I did get warranty, but it only covers the mechanics, and not the lights, ABS, Aircon or Catalyst

Would this be something i could sory myself?

im thinking of removing the bulbs and then using a hair dryer to get the condensation out by poking it thru the bulb place..would this cause any damage?!?

I thought it may be seals, but from what i see, it seems fine. However, the black rubber cap on the light was slightly loose, and is the only thing i suspect that could be letting the condensation in

changing the sidelights with sweaty hands can cause it to steam up/moisture content inside the housing, the u shut it tightly with the rubber cap. then during car washes or when its cold itll steam up inside.

take the rubber cap and let it dry for a bit

AKs_SlickPolo · Post by **AKs_SlickPolo** » Thu Dec 22, 2005 10:51 pm

Just saw another 9N a little while ago and it had the same problem. I think its probably a cold thing...i still want to get it out cos its annoying me

ill leave the cap out and use a hairdryer a little to help it clear up. Cheers dude.

dino · Post by **dino** » Fri Dec 23, 2005 9:05 am

I wouldn't use a hairdryer as you'll be putting more ot air in there.

AKs_SlickPolo · Post by **AKs_SlickPolo** » Fri Dec 23, 2005 8:13 pm

Cheers guys, Camadarron did as u said to take the caps off, drove around with the lights on, and the steam is not too far from gone

Thanks, finally the annoyance is over!