
If not scroll down a bit further

No - i haven't just been doing my hair!
quick how to - buy a new rear badge (or find a very nice Simon)
Separate them and spray the backing with plastic primer, colour and lacquer (or find a very nice Joe)
Stick em back together.
Heat the old badge up for a while (as shown above)
Get dental floss (any flavour will do) and using a sawing motion behind the badge to cut through the sticky foam pad.

What your left with will need removing - i did it with plenty of swearing, heating with a hair dryer and AutoGlym Intensive Tar Remover.


Till you get to this (took me bloody ages) -

Then whack your new sprayed badge on - stuck mine on with Servo Tape (available from all good model shops)


Big thanks to Simon for the badge and Joe for his spraying and warehouse use