bmc induction kit

mwarner87 · Post by **mwarner87** » Fri Jul 13, 2007 5:09 pm

ive jus bought one of these, are they hard to fit?

any sites where there are a guide to fitting?

cheers

Redline · Post by **Redline** » Fri Jul 13, 2007 5:14 pm

A BMC is very easy to fit. You may want to read this:

http://www.tigerstyle.co.uk/poloforum/v ... php?t=1248 (just a note, that guide was written over 4 years ago so don't expect the author to respond!)

And also this too:

http://www.tigerstyle.co.uk/poloforum/v ... hp?t=27451

Kam Racing · Post by **Kam Racing** » Fri Jul 13, 2007 5:47 pm

Redline wrote:A BMC is very easy to fit. You may want to read this:

http://www.tigerstyle.co.uk/poloforum/v ... php?t=1248 (just a note, that guide was written over 4 years ago so don't expect the author to respond!)

And also this too:

http://www.tigerstyle.co.uk/poloforum/v ... hp?t=27451

as you'll have got a silicon 90 degree bend rather than the rubber one you will have to cut it down to size so that it fits under the bonnet. I originally used a hacksaw but a stanley knife was better for getting a straight line..