Removing rear panels to change speakers

Chat about your 9n Polo (inc GT and Fun)
Post Reply
kliis
Getting There!
Posts: 92
Joined: Tue Jan 14, 2003 9:48 pm
Location: Castellar del Vallès, near Barcelona, Catalonia, Spain
Contact:

Removing rear panels to change speakers

Post by kliis »

Hi all!
Anyone knows how to remove the rear panels in a 3 door Polo? I need to remove them to replace my original speakers.
I've read the guide to remove door panels but I can't see any similarity to the rear panels.

Any help will be appreciated! :D
tornado_ally
Silver Member
Posts: 257
Joined: Sun Oct 12, 2003 8:59 pm
Location: London

Post by tornado_ally »

Don't know about removeing the rear panel but when you do eventually do get the panel off the b@stard speakers are bloody rivetted on so you have to cut them out with a good drill. Fun job on a cold day!
Though it shouldn't be that bad in Barca
kliis
Getting There!
Posts: 92
Joined: Tue Jan 14, 2003 9:48 pm
Location: Castellar del Vallès, near Barcelona, Catalonia, Spain
Contact:

Post by kliis »

:( A lot of work... Why do the f**** VW designers do it so difficult? Why not using some standrard screws and that's it?

Anyway, thank you for your reply. Here in Barcelona we are now (14:30) at 10 degrees celsius. In the morning we were at 5! So we have a cold day too.
Scorpio1
Gold Member
Posts: 623
Joined: Sat Jun 28, 2003 10:36 pm
Location: London UK

Post by Scorpio1 »

I have done it and I 'think' there are 5 white clips (same as used on the front doors) they can break easily and best to have some spare. It isn’t too hard but the best and easiest way is to remove the rear seats, but they do pull out and forward etc.

There is also a little black plastic part that meets the rear trim (that holds the parcel shelf) this can easy break but if it does the panel still holds in tight.

I also found on my car there were just 4 normal Philips screws holding in the speakers which is handy but strange since the fronts are rivets.. While you have the panel off it's also an opportunity to stick down any loose wires that might be causing a rattle.
kliis
Getting There!
Posts: 92
Joined: Tue Jan 14, 2003 9:48 pm
Location: Castellar del Vallès, near Barcelona, Catalonia, Spain
Contact:

Post by kliis »

Scorpio1 wrote:While you have the panel off it's also an opportunity to stick down any loose wires that might be causing a rattle.
Yes, that is my problem. A lot of annoying noises whe I pop up the volume :(

So, If I understood you right, it is just pulling the entire panel off?
I'll try not to brake the white clips!

Thank you!
Post Reply