Photo-boredom

[polo_dude]

Took the olop for a spin and took a few photos. What you think? Still alot of changes to go trough but I'm getting there, slowly.

[NOZ]

Looking good. Black doesn't go with that colour so i'd suggest remiving all the black badges etc and colour coding the handles for a sweet look. Its a start

[Torq-Al]

Is that a mk3 VR6 lip spoiler I spy there? Just got one thru' today! Didn't know if it would fit, was gonna make it! How easy was yours to put on?

[Polo96CL]

Looks great on those alloys, although i'd suggest debadging the rear POLO and the 1.6GL. Keep the black badge because I think it looks great. Oh, and update your sig!

[Mike]

I agree it's a moody colour and looking clean would suit it..

[polo_dude]

Cheers for the comments guys, yeah I do agree will take the "Polo" and "1.6GL" badges off once I get the time, it seems all a bit too cultured.

@ Torq-Al: Yeah it's a VR6 splitter/lip, and to be honest, it's easy enough to make but a b*******s to fit. Most of the trimming was done from the middle of each side and then heating the plastic up using a heat gun so that the edges would curve with the 8vavle bumper and that's pretty much it. Get all the measurements done and you'll be fine once your doing it. However fixing it is just mainly with cable ties! A few of the holes line up but not all.

[polo_dude]

@ Polo96CL: Haha, will update the sig too

[Torq-Al]

@ Torq-Al: Yeah it's a VR6 splitter/lip, and to be honest, it's easy enough to make but a ********* to fit. Most of the trimming was done from the middle of each side and then heating the plastic up using a heat gun so that the edges would curve with the 8vavle bumper and that's pretty much it. Get all the measurements done and you'll be fine once your doing it. However fixing it is just mainly with cable ties! A few of the holes line up but not all.

Cheers Dude. All in the preparation then!

[Biddle]

Looking good mate