6n2 Rear Lights

[trav]

there in my house now some one in the leicester area come and fit them for me?

I KNOW THERES A DIY GUIDE BUT I DONT GET IT

would prefer some one to come and do it else i'll f**k up! and i'll obviously pay you

[vw-po-low]

It's easy as pie!

Trim the edges down so the lamps sit flush. Drill the middle hole out about 15mm, where the middle bolt from the lamp will sit.

On the n/s lamp swap over wires 1 and 2.

On the o/s lamp swap over wires 4 and 5.

Also on the o/s plug trim the notches off and turn the plug 180 Degrees so its the wrong way around. Would not take any longer then 30 minutes.

Rob

[b-random]

Rememebr mate the lights are already filed down and will sit flush enough to the bodywork, I found the guide the complete opposite to how they worked on mine, wires worked correct when they were wired up the same as the standard 6n tail lights

use some wire connector lugs

[clarkson]

did u manage to get them workin mate