Greg's Silver Polo Progress Thread - NOW SOLD!!

[gregperkins]

How easy is it to change indicators mate?

Keep up good work.

Relatively easy buddy. Just have to cut the old loom off, and wire the new ones in to the exsisting wires. Il upload a pic later of them flashing

[RS_GT]

loving the upgrades Greg! my BMC should be in by the end of the week, iv found a place for the monster lol. Mine is going to be close to where you have it , that pipe fromt he top of the coolant bottle will run over the CDA. where is you air feed pipe leading to?

[alexperkins]

Runs to underneath the headlight behind the battery tray

Did you order that connector pipe as i recommended

[gregperkins]

loving the upgrades Greg! my BMC should be in by the end of the week, iv found a place for the monster lol. Mine is going to be close to where you have it , that pipe fromt he top of the coolant bottle will run over the CDA. where is you air feed pipe leading to?

Cheers mate ah right sweet, atleast you've found a place to fit it! Its leading to just underneath the headlight. Didnt put it into the fog grill, cos water might go up the pipe or something lol

[Adam-]

Why not use the cold air feed that goes into the arch?! And would water really get up the pipe? Surely it's too much of an angle?

Really sweet car man! Keep it up! (L)

[alexperkins]

on the other side? the pipework would have to go over the manifold and be longer to do it on a 1.0 due to the tb position.

Its effectively in the same place on the pass arch anyhow.

If you are driving in the rain, and the pipe is on the fog grille cutout, it will suck water up into the filter and possibly into the engine

[gregperkins]

what he said ^

[gregperkins]

Why not use the cold air feed that goes into the arch?! And would water really get up the pipe? Surely it's too much of an angle?

Really sweet car man! Keep it up! (L)

Cheers mate Not to much else to be done now im sure il find something to do

[Adam-]

s**t, i never thought about the TB position.

Yeah, that's what i was saying, but i wasn't convinced that the engine could have enough "suck" to get water all the way up that tight angle.
Tbh, the arch is a lesser run anyway, so it's probably the best option.

[RS_GT]

Runs to underneath the headlight behind the battery tray

Did you order that connector pipe as i recommended

cheers Alex, i ordered all the parts you recommended, ordered a reducer for the CDA too, so i can use a 70mm pipe at both ends, instead of having to find someone cut me a 15cm piece of 70mm to extend the TB side piping. is the feed routed to the same place the original feed is on the other side? (above the wheelarch)

[lowfoon]

Thinking of putting the engine cover back on? Interested of how you may do this..

[gregperkins]

No i'm not mate, it wont fit Might paint the engine though on the top

[RS_GT]

No i'm not mate, it wont fit Might paint the engine though on the top

thats my plan lol, plenty of lime green paint left

[gregperkins]

No i'm not mate, it wont fit Might paint the engine though on the top

thats my plan lol, plenty of lime green paint left

Haha good idea I will probs paint mine red. I Should have got a red 90 degree bend tbh!

[gregperkins]

Just ordered some LED front indicator bulbs from HID's 4 U