Boost gauge

[g__humm]

Where is the best place to tap the line into and also. Where is the best grommet to go through I
have the vent pod

[88rsr]

we talkin diesel i assume? some egr delete kits have a takeoff on them for the boost gauge, if not i drilled into the hard plastic boost pipe toward the rear of the engine on dsw88's polo, used a tyre valve through thatand a couple of bits to adapt it to the size of the pipe that comes with boost gauges, hes probably had it on over 15k or more without problem, i think i put it through somewhere around the passenger footwell area, theres probably somewhere closer to the drivers vent though but his were going in the dash above the stereo etc,

[88rsr]

pics of the take off, i didnt have any black high temp silicone only white lol....

[g__humm]

Thanks and where did u go through the bulk head?

[88rsr]

somewhere near the gearbox i think, but cant remember exactly i made sure the pipe was plenty long enough thats all

[g__humm]

Got mine going through a gromet near door and through wing eventually

[88rsr]

not much to go through really on these 9ns is there

[K.I.T.T.]

Bonnet release cable grommet for LHD cars. 4 AWG cable fits, and then some. Here are a few pics of my car:





Ash

Edit: Didn't read the bit where you said you got it through Ah well, ^^for future reference