First off i fitted my Sill trims they are really easy to do, You just need 2 pairs of hands (Not supplied)
You need to clean the sill where the trim will sit, I used a damp cloth first then dried off with a microfibre cloth.
You do get an alcohol cleaning and activator sachet in with the trims but i wanted to make sure the sill was as clean as possible so i used some carl ziess lens cleaning cloths which contains isopropyl.
I let this dry off for a few minutes then did my measuring. Tip measure measure measure. Once your happy mark around the outer edge with a soft pencil.
Do this for both sides of the car.
Then open the sachet that that comes with the trim and wipe over the area avoiding the pencil marks.
Do this for both sides turn your cloth over for the other side of the car.
Let this vent off for 5 mins
Now it's squeeky bum time as the glue on these trims is ultra sticky
Peel the 2 end pieces of backing off then pull the the 2 pieces of long backing about 40mm
Then line up your trim with the pencil mark and press lightly ( I used a depth gauge so i got the correct spacing from the front edge of the sill)
Then get your 2nd pair of hands to lightly press the trim as you go along pulling the backing off and checking that the trim is running with the correct spacing.
Once done get you micro fibre cloth and apply pressure to the trim i put my full weight on it as i rubbed back and forth to make sure it was stuck down.
Job Done now do the same for the other side.
Here are some pics of before and after
It really is easy to do just take your time.
Next i fitted my Audi exhaust trim
From this
To this
Next up i thought i would fit my LED number plate lights that i bought from HID4U
My old lamp
New led lamp
I did a little bit of a mod to the lamp as i found they rattle abit in the bumper so i got 2 pieces of cloth loom tape and applied it to the back of the lamp. No more rattles
i likeeeee 
