crosspolo2014 wrote: i think somewhere in VCDS is a adjusting of the voltage for the led's. but where??
You should consider that your LED module is powered by the wiring of the side lights. Therefore, with harness adapters would not be possible to change the voltage of the LED module.
Considering that all parts are new and they are working properly, let's start by more simple way to discard electronic bugs or bad contacts between connectors:
Soft Reset
: Unplug the harness adapters and reconnect. From T14 and T10 only.
Check LEDs.
Hard Reset
: Disconnect the battery for a few minutes. (5 minutes is enough)
Check LEDs.
Remember that after you have to enter the PIN code of the radionavigation and restore function comfort electric windows. (user manual)
It seems clear that the failure of the LEDs is related to voltage fluctuation. Checks if after driving more than 20 minutes, the LEDs have the same problem.
Deceiving the lights setup to change the performance of the same, you can enter the following encodings in your BCM:
22B02B3F08E12400923008002D2B0CD0F0C043FF60060000200000000000 Check LEDs, all lights, one by one, and no faults in BCM.
or
22B02B3F08E12400923008002D2B0CD0F0C047FF60060000200000000000 Check LEDs, all lights, one by one, and no faults in BCM.
Although these changes in the coding of the BCM may not solve the problem.
Copy and paste as explained here:
http://www.uk-polos.net/view ... 95#p483792
Restore your old coding if nothing is solved:
22B02B3F08E12400923008002D2B0CD0F0C041FF60060000200000000000
We hope your feedback.