Ok so the "vehicle specific installintion instructions are as follows below"
VOLKSWAGEN POLO
LOCATION
Compact alarms and sirens Control units and modules
RUNNING OF ALARM WIRING SUPPLY
Positive and negative
PROVISIONAL
- Year of registration 2002 - 2005
On the driver side shock absorber support.
Under the driver side dash.
Use the original core hitch for the heating tube, place in the middle of the
engine compartment, on the fireproof bulkhead. To the battery poles.
page1image6760 page1image6920 page1image7080 page1image7240
FUNCTION AND CONNECTION PROCEDURE
WIRE COLOUR OF THE VEHICLE
page1image10400
WIRE POSITION
TURN SIGNAL:
page1image12576 page1image12736
BLACK-WHITE 1,5 mm2. BLACK-GREEN 1,5 mm2
Connector: BLACK 16-way signed XS6 connected to the unit placed under the driver side dash.
Position: Nr. 16 e Nr. 14.
page1image16568
POSITIVE UNDER KEY:
page1image18032 page1image18192
BLACK 1 mm2.
Connettore: LIGHT BROWN 18-way signed XS4 connected to the unit fixed under the driver side dash.
Position: Nr. 12.
page1image21696
1ST ENGINE IMMOBILISER: (Starter motor).
.
page1image23504
RED-BLACK 2,5 mm2.
Wiring harness coming from the ignition key switch.
2ND ENGINE IMMOBILISER: (Fuel pump – gasoline vehicles).
page1image27968
BLACK 0,5 mm2.
Connected to the relay of the fuel pump, signed 167 fixed on the bracket placed on the steering column left side. Position: Nr. 86 of the relay.
2ND ENGINE IMMOBILISER: (Solenoid valve – diesel vehicle).
page1image32560
BLACK-LIGHT BLUE 1 mm2.
Connected at the back of the rear of the fuse box, corresponding to the 5A fuse Nr. 17
CDL – ELECTRICAL SUNROOF AND ELECTRICAL
LIGHT BLUE-WHITE 0,75 mm2.
Connector: BLACK 23-way connected to the unit fixed on the right of the steering column (it is necessary to remove the aeration tube, near the brake pedal).
Position: N. 6.
page1image40568 page1image40728
WINDOW-WINDER (Ver. 2002 - 2004):
negative common.
page1image42880 page1image43040
CDL (Ver. 2005): Diagram Nr. 31. negative common.
page1image44928 page1image45088
LIGHT BLUE-WHITE 0,75 mm2.
Connector: BLACK 23-way connected to the unit fixed over the brake pedal (it is necessary to remove the aeration tube, near the brake pedal).
Position: Nr. 6.
page1image49528
CDL – ELECTRICAL SUNROOF AND ELECTRICAL
LIGHT BLUE-WHITE 0,75 mm2.
Connector: BLACK-VIOLET 8-way connected to the window winder motor inside the driver side door.
Position: Nr. 5.
page1image53920 page1image54080
WINDOW-WINDER (Ver. 2005):
negative common.
page1image56152 page1image56312
DOORS SWITCH:
page1image57904 page1image58328 page1image58488 page1image59920
Roof light
page1image60568 page1image62336 page1image62496
BROWN-BLACK 0,75 mm2.
Connector: BLACK 5-way signed XP4 connected to the unit fixed under the driver side dash.
Position: Nr. 1.
page1image65720
BONNET SWITCH:
page1image67144 page1image67304
BROWN-RED 0,75 mm2
If this wire is not available, install the provided switch on over the driver side front headlight).
Connected to the micro-switch placed in the bonnet mechanical lock.
page1image71352
TRUNK SWITCH:
page1image72936
BROWN-GREY 0,75 mm2.
Connector: RED 6-way XS5 connected to the unit placed under the driver side dash.
Position: Nr. 4.
page1image76544
page1image80416NOTE: ALL INFORMATION INCLUDED IN THESE SPECIFICATIONS ARE MERELY INDICATIVE AND NOT RESTRICTIVE.
Seems about as much use as a chocolate fire guard.
So. i havent even touched fitting the alarm section yet i just concentrated on central locking.
Behind the bonnet release there is the cables going into the door, i released these and from my understanding the white and blue cable should be the central locking system. I need a resister of 1k ohms on the unlock wire but both lock and unlock plug into that same white and blue wire. So i just hooked up the lock and gave it a try, to nothing. alot of clicking from the receiver but no locking.
I even ripped the doors apart to look at fitting new servos as that could be easier but they dont appear compatible.
Has anyone fitted something like this before that could give me a little help as to where i might be going wrong. cant understand why it isn't firing the locks.
thanks
